0
What else can I help you with?
What is the firing order for a 1979 Honda goldwing 1000 GL motorcycle?
What is thw firing order for a 79 Honda goldwing
Spark plug gap for a 79 Honda goldwing?
The 1979 Honda motorcycle spark plug gap is .013. Most spark plugs will come pre-gapped from the spark plug manufacturer.
What is the engine oil capacity on a 1979 Honda cb650?
The oil crank case should hold a little more than 3.5 quarts of motorcycle oil.
What is the horsepower on a 1979 Honda Goldwing?
The 1979 Honda Goldwing horsepower is listed as 79 horsepower.
When was Ian Hutchinson - motorcycle racer - born?
Ian Hutchinson - motorcycle racer - was born in 1979.
Diagram on fuel lines for 1979 xs1100?
For a 1979 Yamaha XS1100, the fuel lines typically run from the fuel tank to the petcock (fuel valve), then to the carburetors. The petcock has positions for "On," "Off," and "Reserve," directing fuel flow accordingly. From the petcock, the fuel line branches into four separate lines leading to each of the carburetors. It's essential to ensure that the fuel lines are routed properly to avoid kinks and ensure optimal fuel flow.
How old is your Honda XR80?
The Honda XR80 was produced from 1979 to 2003.
When did wearing a motorcycle helmet become law in nsw?
1979
What is the spark plug gap for a 1979 Honda cb750k using ngk d8ea?
what is the spark plug gap for a 1979 Honda odyssey
How do you remove a radiator from 1979 trans am?
To remove the radiator from a 1979 Trans Am, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant by opening the petcock at the bottom of the radiator. Next, disconnect the upper and lower radiator hoses, remove any mounting bolts or brackets holding the radiator in place, and carefully lift the radiator out of the engine bay. Finally, check for any additional components like transmission lines that may need to be disconnected.
How do you remove the brake switch on a 1979 Honda NC50?
To remove the brake switch on a 1979 Honda NC50, first, disconnect the battery to ensure safety. Locate the brake switch, typically found near the brake lever or pedal, and carefully detach any wiring connected to it. Use a suitable tool to unscrew the switch from its mounting position. Once removed, you can replace it or perform any necessary maintenance.
Where is the oil filter on a 1979 Kawasaki 750 motorcycle?
underneath the motor...
