answersLogoWhite

0

On the Interstate you have to loosen a set screw on the headlight adjustment knob (between the speedometer and the fairing) Remove the knob then the 17mm. nut holding the bulb assembly in. The entire unit will then come out from the front of the bike. replace the bulb (H4 type) reinstall, the unit tighten the nut,replace the adjustment knob, tighten the set screw. It should only take you 5 or 10 minutes tops. GOOD LUCK! On the Interstate you have to loosen a set screw on the headlight adjustment knob (between the speedometer and the fairing) Remove the knob then the 17mm. nut holding the bulb assembly in. The entire unit will then come out from the front of the bike. replace the bulb (H4 type) reinstall, the unit tighten the nut,replace the adjustment knob, tighten the set screw. It should only take you 5 or 10 minutes tops. GOOD LUCK!

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What bulb is in the headlight of a 1983 Honda Goldwing Aspencade?

The headlight bulb in a 1983 Honda Goldwing Aspencade is typically an H4 type bulb. This bulb provides both high and low beam functionality. It's important to check the owner's manual or consult a parts dealer for specific details, as there may be variations based on modifications or regional specifications.


What is the proper weight motor oil for 1983 Honda goldwing?

Use Honda 10w40 and you will not go wrong.


What is the fork oil capacity for 1983 Honda Goldwing gl1100?

9.8 ounces


What is the shifting pattern on a 1983 Honda Goldwing GL1100?

1 down, and 4 up


Your 1983 Honda goldwing bogs out in overdrive?

More info. At what speed and what's the rev's?


How much compression should a 1983 Honda goldwing have?

150psi , per. cyl. J.H


What Brake oil do you use for a 1983 Honda Goldwing Aspencade GL1100?

dot 3 or 4


What is the tire size for the 1983 Honda GL Goldwing 1100?

Front tire: 110/90-19Rear tire: 130/90-17


What is the value of the 1983 Honda goldwing gl interstate 1200 vgc 47000 miles?

look for about £1800 - £2000 for one in tip top condition


What headlight can be used to replace 1983 Honda scooter 80?

To replace the headlight on a 1983 Honda Scooter 80, you can typically use a 6V 35W halogen bulb, which is a common type for vintage scooters. It's important to check the scooter's manual or consult with a motorcycle parts dealer to confirm compatibility. Some users also opt for a 6V LED replacement for improved brightness and efficiency. Always ensure that the replacement bulb matches the original specifications for safe operation.


How do you change the stator in a 1983 Honda goldwing?

Have to remove the engine for this job. Takes anywhere fron 10 to 15 hours for the job. The part cost is from $ 150.00 to $ 250.00.


How do you install a Starter on a 1983 Honda 1100 Goldwing?

remove battery cable remove gear change lever remove two bolts thru starter then work it out .' that's it