no thee is not a reset if light stays on need to install a oilpressure gauge and check oilpressure sounds like serious engine damage has occured hope not!!!!!!
To restart your boiler after running out of oil, first, refill the oil tank. Next, locate the boiler's reset button, usually found on the burner control. Press the reset button to restart the burner; it may take a few minutes for the system to prime and start. If the boiler doesn't restart, you may need to bleed the oil line to remove any air trapped in the system.
how much oil in 1996 CBR 900RR
It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.
http://www.bossturbo.com/cbr/howto_oilchange.shtml
put oil in it,there is no reset if the oil is not low the sensor in the pan or wiring to sensor has a problem
A low oil pressure gauge has no reset. It comes on to tell you that the oil pressure is dangerously low. It will not go off until the pressure is restored. You may be low of oil or the pressure sensors may be defective.
The fuel shut off switch could have tripped, reset it if it has.
If you are referring to the oil light then you do not reset it. The oil light comes on when it detects low oil pressure. The light will go out when the problem is corrected. Can be the engine is low of oil, does not have sufficient pressure, or the oil pressure sending unit it bad.
Oil pressure lights are not reset. You need to find out why the oil pressure light is on. Normally this means you have low oil pressure.
For the Honda CBR 400 basic oil is used for the motor. You can purchase the oil at a local auto parts store such as auto zone.
My 2003 ford expedition stalled after the high temp low oil light came on. How can i restart my truck?
99 percent sure there is NO oil reset procedure for the '97 sc models. If your oil light is on it is bc you are LOW on oil. Add oil immediately