answersLogoWhite

0

the gl1100 has 4 air cut off valves they are located on the side of each carb. under the flat 2 screw cap. I may be incorrect about how many screws it could be 3 I don't remember for sure. but it is definitely on the side of each carb

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you access the radiator cap on a 1981 Honda goldwing gl1100?

If I remember correctly, the rad. cap in in the lower front corner. If you remove the tray on top of the air filter, look in the front right lower corner.


Goldwing questionwill 1100 shocks fit on 1200?

GL1200 shocks are about 3/4in longer than the GL1100 shocks. Putting them on a 1200 will lower the rear slightly. I'm not sure about the air connections or the mounting bolt size.


What is the location of the idle air control valve in a ford expedition?

its on the throttle body


Pcv valve location Chrysler town and country 2000?

The Chrysler Town and Country PCV valve can be found on the outside of the air cleaner housing. The PCV valve will be attached to the back of the air cleaner housing.


Camry Idle air control valve location?

Its on the back side of the throttle body.


Location of idle air control valve on dodge shadow?

Depends on engine and year


Where is the location of 1994 Jetta PCV valve?

The 1994 VW Jetta PCV valve is located on the outside of the air cleaner housing. You can find the valve on the back side of the housing.


Where is the location of the PCV on a 2001 VW Golf VW calls it a CVV valve.?

The 2001 VW PCV valve can be found on the clean air hose. The clean air hose will go from the air filter housing to the top of the engine.


Does the front air forks on a goldwing still use fork oil?

Yes.


Where is the location of 2004 Chevy Malibu idle air control valve?

Is it inside the engine it self on top


What is the type of air valve?

if you are asking about the air valve on the tire to add/let out air then it is a schrader valve or an American valve


How do you bled air out of a clutch line on a 86 Honda goldwing aspencade?

First make sure that the master is full, follow the d.o.t. spec's for the fluid. The valve is located at the rear of the engine where the clutch goes in. Loosen the bleeder first, then tighten it up. Have someone depress the clutch, while they hold the clutch in, you open the valve, the fluid and air will come out, tighten the valve, and tell the person to release the clutch. Repeat this several times to get all the air out. Re-fill the master each time.