94 ft/lbs rear axle nut
94 ft/lbs front axle nut
14.5 ft/lbs front axle clamp bolts
I've also seen 92ft/lbs for the axles, I would use the 92 since it's the lower number, but it's not off by much so there you go, enjoy
The torque specification for the front wheel axle nut on a Kawasaki Vulcan 1500 is typically around 72 ft-lb (98 Nm). For the brake caliper mounting bolts, the torque is usually in the range of 20-25 ft-lb (27-34 Nm). Always refer to the specific model's service manual for the most accurate and detailed specifications.
Front axle = 55 lbf-ft. Pinch bolts = 9 lbf-ft. Rear axle = 80 lbf-ft.
The 2007 Harley-Davidson Fat Boy has front axle torque specifications of 50-55 ft-lbs and rear axle torque specifications of 70-80 ft-lbs. It's essential to use the correct torque settings to ensure safe and optimal performance. Always refer to the owner's manual or service manual for the most accurate and detailed information.
The axle torque specifications for a 2005 Scion can vary depending on the specific model (e.g., Scion xA, xB, etc.) and the type of axle (front or rear). Generally, the torque values for axle nuts typically range from about 75 to 100 ft-lbs. For precise specifications, it's best to consult the vehicle's service manual or a repair guide specific to your model.
The front axle torque specification for a 2004 Mercury Mountaineer typically ranges around 75-85 ft-lbs for the axle nuts. However, it's always best to consult the vehicle's service manual for the most accurate and specific torque specifications, as variations can exist based on the drivetrain configuration.
The axle torque specifications for a Freightliner can vary depending on the specific model and axle type. Generally, the axle nut torque for most Freightliner trucks ranges from 250 to 450 ft-lbs, but it is essential to consult the vehicle's service manual for the exact specifications relevant to your specific model and configuration. Always follow the manufacturer's guidelines to ensure proper installation and safety.
Axle nut torque specs are 170-203 ft.lbs
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
The front axle nut on a 1997 Nissan Maxima typically has a size of 32mm. It's important to use the correct size for proper torque and to avoid damaging the nut or axle during removal or installation. Always refer to a repair manual for specific torque specifications and procedures when working on vehicle components.
A front axle holds the front wheels on and on front-wheel drive vehicles transmits engine torque to the wheels. --Ken
103 ft lbs. See torque specifications chart at: http://cds.activant.com/C2C/C01/35/192/157591741.pdf
The 2001 Forrester front drive axle nut torque specification is 90 pounds. The front drive axle nut should be torqued in 45 pound intervals.