0
What else can I help you with?
How do you many clutch plates in a Yamaha blaster clutch?
there should be 6 clutch plates
How do you replace a clutch on a Yamaha blaster step by step?
Buy a yamaha blaster manual. Shows you step by step picture by picture.
Why wont your Yamaha blaster go into gear?
A Yamaha Blaster not going into gear is typically a sign of an issue with the clutch. To troubleshoot, try to adjust the clutch at the lever. If this doesn't solve the problem, the shot clutch pack may need to be replaced.
Is there a certain order to put clutch plates in a Yamaha blaster?
7. the answer is 7
Yamaha blaster and its stuck in gear No matter what you do you cant shift into neutral or any other gear for that matter Somebdy please help me?
Does it have gear lube in the case? If so you will need to inspect clutch basket may need new clutch or clutch springs may have failed
Where is oil pump on 2003 Yamaha Blaster?
It is located on the right side of the engine and is the most forward part of the clutch cover
Why wont my clutch lever work on your Yamaha blaster?
Well cable could be froze up. Replace the clutch cable. If cable is working adjust cable. If the clutch cable is adjusted then it's time for a new clutch
How does a pressure work?
a pressure plate works by springs. when disengaged the tension is released from the springs which hold the clutch plate against the flywheel,allowing the clutch plate to spin free,which basically stops the transfer of power from engine to gearbox when clutch is engaged the tension is reapplied to springs in pressure plate forcing the clutch plate against the flywheel
What does the clutch look like in a 1990 Yamaha blaster?
the plates are round with a cork like coating on the outer surface about 3/4" wide
What kind of oil do you put in the crank case of a 2000 Yamaha blaster?
23.67 ozs and I use Spectro Clutch Saver 10W 40
How-to change clutch cover on Yamaha r1?
How-to change clutch cover on yamaha r1?
Which way is the clutch installed on a 1994 Toyota pickup which way do you face the springs on the clutch to the pressure plate or to the fly wheel?
Just make the clutch pads line up with the clutch disk. the pressure plate can only go on one way due to the positioning dowels
