Putting gas into the oil of a 4-stroke ATV, and running it can cause damage if oil is diluted enough. Gas is not a lubricant and bearing/cylinder wall damage can occur. drain the oil and refill with clean oil.
needle and seat leaking by
You get engine damage from lack of lubrication
Use 4 cycle oil if the engine is a 4 cycle engine. Use 2 cycle if it is a 2 cycle. Use the weight oil recommended by the manufacture of your ATV.
It will not hurt the engine what so ever, But it will make it smoke and might fowl out a spark plug.
Use Automatic Transmission/Engine Oil for ATV's ONLY! Find it at your local ATV Shop.
No you can not use gas engine oil in diesel engine oil because processing of diesel engine is different from gas engine oil. If you use this then it damage your vehicles.
A gas only engine has a spout where oil is added to the engine. If there is no spout, then it is a gas/oil engine. FYI - gas only engine is a four-stroke (four-cycle) engine and the gas/oil engine is two-stroke (two-cycle).
You will lose all lubrication to the engine, and if you run the engine long enough you will have catostrophic engine failure.
Oil mix for 2 stroke kids arc
1 litre
Two quarts.
To change the oil on a 2004 Honda Rincon ATV, first, warm up the engine slightly to thin the oil, making it easier to drain. Then, turn off the engine and place the ATV on a level surface. Remove the oil drain plug located at the bottom of the engine and allow the oil to fully drain into a container. Replace the drain plug, fill the engine with new oil through the dipstick tube using the recommended oil type, and check the oil level to ensure it’s within the proper range.