0
The proper setting is based on the air available. This is to say your location above sea level. The closer you are to sea level the more fuel an engine can burn. The further you are from sea level the thinner the air or less oxygen available the less fuel you are able to burn. When you set the screw you can get an idea of the correct setting by how quick the throttle response. When you have gone to far which is giving the engine to much fuel mixture the throttle response will slow. Start with it turned almost all the way in and turn out 1/4 turn until the throttle response slows then turn back in 1/2 turn.
What else can I help you with?
What is the air fuel screw setting on a 1985 Honda rebel 250?
2 turns out from seated is a good start
Your 92 cr250 idles high how can you adjust this?
You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.
Idle fuel mixture setting for 68 250 Chevy?
the best way to set the idle mixture screw is with a gas analyzer. setting the mixture to 14:1. if you dont have one use a vacuum gage and set for the highest vacuum. If you dont have one of them then turn the screw in til the engine starts to stumble. then turn the screw out til the engine starts to stumble. turn the screw back in half the distance. that will be your best setting. Any leaner and the engine wont start, any richer and the engine will flood.
How many turns out on the fuel screw on a 1992 Honda nighthawk 250?
two and half turns (so it is 5half turns)
What iron setting is 250 degrees?
Most curling and clothes irons have a setting of 250 degrees. Depending on the iron, 250 degrees can be a low or a high setting.
When you hook up the air intake hose to the filter the bike wont start its a suzuki 250 quadrunner?
u need to set the air fuel screw
When was the Archimedes screw invented?
The Archimedes screw was invented in 250 B.C.
Is there a screw that you can turn to increase fuel delivery to a 1997 Ford F-250 7.3 diesel.?
No, there's not. It is an electronic engine, any fuel increases have to be done through computer reprogramming. There are tons of aftermarket chips that can be used to accomplish this.
Where is the idle screw in a 1999 yz 250?
twist the top of the choke, there is no idle screw on the 1999 yz250
Where is the fuel fiter on 2002 f-250 ford diesel truck?
fuel filter on 2002 ford diesel is on top of engine. on top of engine is a round cannister with a screw on top this top will be either black or brown unscrew this cap to change filter
1998 timberwolf 250 4x4 has a increase-decrease screw what is it?
for your clutch
What are the adjustments for the gas and air screws on a 2000 polaris trailblazer 250?
Turn the fuel/air screw all the way in. Then back out about 1/4 turn. That should get you close. May have to tweek alittle in or out.
