The Compensating Nut on a Harley is torqued to 150-165 ft-lbs. Use two drops of Locktite threadlocker 262 (red) on the threads. Use the locking tool to keep the primary from rotating. Don
Your local dealership can give you this info or you can go to the library and look up the tork settings in a auto repair manual. But, you still will need a tork wrench. If you don't have a access to a tork wrench a good rule of thumb is to snugg up the adjusting nut somewhat tight and then back off the nut 1/4 turn. This will put the tork setting very close to the manual recommended setting, and will be just fine.
Rear wheel bearing nut tork setting
The compensator torque specifications for a 1975 Harley-Davidson FLH typically require the compensator nut to be torqued to 65-75 ft-lbs. It’s important to use a torque wrench to ensure accuracy and avoid damage to the components. Always refer to the specific service manual for detailed instructions and specifications, as they can provide the most reliable guidance for maintenance and repairs.
What is the crank tork and rod tork on a 1996 Geo Tracker 1.6 Engine Block number G16A What foot pounds do they tork to??
Bareh Tork's population is 161.
The population of Tork Amir is 51.
Taraqi Tork's population is 939.
Peter Tork was born on February 13, 1942.
Peter Tork was born on February 13, 1942.
Hanan Tork was born on 1975-03-07.
Dave Tork was born on 1934-08-25.
The population of Baqerabad-e Tork is 399.