answersLogoWhite

0

Cold engine settings Inlet 0.10mm Exhaust 0.25mm.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What are the valve clearance of 4BE1 Isuzu engine?

.14 mm on 4be1


What is the valve clearance of Isuzu C190 engine?

intake valve - .012inch. exhaust valve - .014inch.


What is the valve clearance of TD42 4.2L?

.35mm or 14 thou.....


What is the valve clearance for 4d32 Mitsubishi engine?

Oh, dude, you're asking about valve clearance for a 4D32 Mitsubishi engine? It's like the holy grail of car maintenance questions! The valve clearance for that bad boy is typically around 0.25mm for both intake and exhaust valves. But hey, if you're not feeling up to the task, just take it to a mechanic and let them deal with all that technical stuff, right?


What is the valve clearance of mitsubishi pajero 4d56?

The valve clearance of a Mitsubishi Pajero 4d56 is 14. Typically, engines have either a 14 gap or 16 gap clearance.


What is the valve settings on a FC42OV kawasaki 14 hp gas engine?

For the Kawasaki FC420V 14 HP gas engine, the valve clearance settings are typically 0.15 mm (0.006 in) for both the intake and exhaust valves. It's important to check the specific service manual for your engine model, as settings can vary slightly based on production year or specific configurations. Always ensure the engine is at top dead center on the compression stroke when adjusting the valves for accurate measurements.


What is the Valve clearance for the 2002 kia pregio diesel j2 motor?

J2 engines are as follows Inlet: 10 or 12 thou, Exhaust: 14 thou.


What is the size of tire on Renault clio grande 1.2?

14"


Renault clio toque settings for cylinder head?

hi clio 14 rt 97 have you got the cylinder head toque setting for this car thanks


14 thou both intake exhaust is that right?

Generally the exhaust lash is more than the intake. The engine data plate should have the valve lash info stamped on it.


Valve adjustment on 95 lumina?

This vehicle is equipped with hydraulic valve lifters that do not require adjustment. They are set at zero lash by tightening the rocker arm nuts to 14-20 ft. lbs. If you hear a little valvetrain noise coming from your 3.1L engine, this is normal.


Where is the fuse for clearance lights on a 14 prostar plus?

On a 2014 ProStar Plus, the fuse for the clearance lights is typically located in the fuse panel, which is usually found under the dashboard on the driver's side or in the engine compartment. You can refer to the owner's manual for the exact location and identification of the specific fuse. Make sure to check the fuse diagram for the correct amperage and position. If the clearance lights are not functioning, inspect the fuse to see if it needs replacement.