17 mm.
The drain plug is on the frame, just behind the front wheel.
Not sure of the size but here are the Yamaha part numbers 3VD-13455-00-00 Plug 214-11198-01-00 Gasket Hope This Helps.
The oil drain plug for a GSXR 600 is on the bottom of the motor, usually near the rear of the bike. You will need to remove the fairing to get to it, and it will be the largest "bolt" on the bottom of the bike.
http://www.bossturbo.com/cbr/howto_oilchange.shtml
0.7-0.8mm or 0.028-0.031in
Hi,i have a 2001 rover and the plug is under the dashboard directly under the steering wheel...
Group 34, approx 600 cold crank amps
It is in the middle of the block. Under left front wheel look for wire and reach in with left hand. Wire/socket to connect to plug points up. I found it but cannot get an answer on plug wrench size. Good Luck had the same problem use the tools under the seat a liitle akward but gets the job done
Let the bike cool take the drain plug out of the oil pan lokated on the botome of the engine. Remove the filter. Replace the filter between the headers relace the oil pan drain plug and fill on right side under cover plate read owners manuale
Group size 34, 500 to 600 cold crank amps
you use an Allen key to remove the drain plug on the bottom of the motor there is an opening in the skid plate that lets you get to it and let it drain replace the plug and remove your oil filter put some fresh oil on the seal and replace and ad 2 quarts of oil and you should be good i just did mine yesterday