answersLogoWhite

0

The leak could come from: hoses, punctured radiator, split gasket...you can put tracer dye in the coolant and search for the leak with a black light after you clean the engine.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you change the coolant on a 2001 Yamaha grizzly 600 ATV?

The 2001 grizzly 600 ATV is "Air Cooled". There is no coolant. The little radiator in the front is an oil cooler.


Will it hurt an ATV if you put stop leak in it?

Using stop leak in an ATV can potentially cause more harm than good. While it may temporarily seal small leaks, it can also clog filters and passages, leading to reduced performance or damage to the engine and cooling system. It's best to address the underlying issue directly rather than relying on stop leak products. Always consult your ATV's manual or a professional mechanic for the best solution.


How do you drain coolant on Honda rancher ATV?

To drain the coolant on a Honda Rancher ATV, first ensure the engine is cool and then locate the coolant drain bolt, typically found at the bottom of the water pump or the engine block. Place a container beneath the drain bolt to catch the coolant, then remove the bolt and allow the coolant to fully drain out. After draining, replace the drain bolt securely, and refill the cooling system with the appropriate type and amount of coolant. Always check for leaks and ensure the system is properly bled of air before operating the ATV.


Why is coolant leaking from crankcase on Polaris 400 ATV?

the mechanical seal on the water pump is out


When I hit the gas on my ATV it bogs down Why?

Improper jetting, improper carb. adjustments, improper ignition timing, improper valve clearance, and a small air leak could also cause this problem.


How do you drain coolant from an Arctic Cat ATV 650 v2?

To drain the coolant from an Arctic Cat ATV 650 V2, first ensure the engine is cool and remove the radiator cap. Locate the coolant drain plug, usually found at the bottom of the radiator or engine, and place a container underneath to catch the coolant. Remove the drain plug to allow the coolant to flow out completely. Once drained, replace the drain plug, and refill the system with fresh coolant as needed.


Would a Z400 ATV beat an YFZ450 ATV?

NO


If a motorcycle or ATV turns over but won't start what would be the most probable cause?

if a motorcycle or atv turns over but won,t start which of the following would be the most probable cause? a. defective charging system rectifier b.defective regulator c.open solenoid coil d.shorted ignition coil


Where to put coolant in a arctic cat ATV?

To add coolant to an Arctic Cat ATV, first locate the coolant reservoir, which is typically found near the engine or under the seat. Remove the cap from the reservoir and check the coolant level; if it's low, pour the appropriate coolant mixture (usually a 50/50 mix of antifreeze and distilled water) into the reservoir until it reaches the recommended level. Always ensure the engine is cool before adding coolant to avoid burns. Finally, securely replace the cap after filling.


What causes gas to leak out bottom of carburetor on ATV?

If it's coming out the overflow pipe, then it's likely to be a sticking float.


How change coolant in a Honda rancher 420 ATV?

To change the coolant in a Honda Rancher 420 ATV, start by ensuring the engine is cool and then place a drain pan under the radiator. Remove the radiator cap and drain the old coolant by loosening the drain bolt at the bottom of the radiator. Once drained, close the drain bolt, fill the radiator with new coolant (typically a mix of antifreeze and distilled water), and replace the radiator cap. Finally, run the engine for a few minutes to circulate the new coolant, check for leaks, and top off if necessary.


Where is the drain plug for a 2006 arctic cat 650 h1 ATV?

Where is the coolant drain plug on 2005 Arctic Cat 650 H1