answersLogoWhite

0

in the oil filler tube... ie the same place you check the oil level

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where do you put the rear end oil in a yard machine lawn mower?

you dont it is packed with grease from the manufacturer


Where can we find diagrams that show how to change belts on an mtd yard machine model 13aq608h729?

Go to www.mtdproducts.com You can put your model number and get a parts breakdown. If you use your model number and serail number you can get the owners manual too.


How much oil do you put in a 8hp yard machine?

For an 8hp yard machine, the oil capacity typically ranges from 20 to 24 ounces (or about 0.6 to 0.7 liters). It's important to check the owner’s manual for the specific model to ensure the correct amount and type of oil. Always check the oil level using the dipstick after filling to avoid overfilling.


Where do you put paper so it can be recycled?

you put your paper in the blue recycle box, and it goes to the recycling yard , and gets put into a machine.


How do you change the drive belt on a 155C John Deere Mower?

To replace the belt on a yard machine 521 mtd 3.5 Hp edger one must obtain the proper tools, the proper parts, and the proper instructions for the machines replacement.


Will gas put in a ride on lawn mower where oil goes ruin the machine and how should it be cleaned?

If you do not run it with the gas in the oil it wont hurt anything. Just drain the oil and put new oil in should run it for a little then change the oil again.


How do you put Arnold corp rear-mounted bagger for mtd and yard-man riding mowers - for 2002--09 mtd and yard-man mowers with 38in and 42in decks togethier?

Well, the model should be a 190-063-000, 190-103-000, OEM 190-063 or OEM 190-103. I would bet on the latter two. Arnold Corp. is a division of MTD, so they are OEM equipment. a parts breakdown would be at the first link below. The second link is for the manual and you must enter the first model number listed above and use a 1 for the serial number. Pick the first in the list, the 770-7212j to get the manual.


Where is the model number on a MTD log splitter?

You may want to check the underside of the beam, they sometimes put them there.


Can you put a pool in a shady yard?

You can put a pool in any yard it doesn't matter.


How do you make a MTD Lawn machine mower a dually?

Take a metal pipe a wide one and weld it to the rim of the other tire... center it and then weld the other side to other rim... have hollor solid pipe so u can put on and take off


How much oil to fill a mtd snowblower?

Put in a full liter. The engine has no oil pressure so oil is circulated by a "slinger", therefore in order to maintain good oil coverage on uneven or steep slopes the dipstick should show "over full". Baxter I've been working on small engines for a long time and this is really the first time I hear this. I usually put about 3/4 of a liter or until the dipstick shows full. Putting too much oil is never recommended in the owner's manuals.


What tractor does model 190-621 snowthrower fit?

It was made from 1996-98 and would fit the MTD 600 series, some Cub Cadet and Whites. All are MTD brands. It could be put on the 1995. It was replaced by the 190-627 in 1999. Manuals are available from MTD at link below by typing in the number you gave as the model and just a 1 for the serial number