answersLogoWhite

0

my 89didnt have one. I just took the hose off from bottom right side of the radiator. Make sure you don't split the hose while doing so. If theres crustaceans Be gentle with a flathead screw driver twist it a little but don't rip it it'll come off. After that I just flushed with water and seals it back up

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Vin location 1986 Honda trx250r?

Steering neck...


Where is Coolant drain 1986 Honda VT1100C?

The bolt to drain the coolant is on the water pump. The water pump is on the left side of the bike, just in front of the oil filter. Just remove the 10mm bolt CLOSEST TO THE OIL FILTER. You'll want to remove the radiator cap prior to doing this so the coolant drains freely. NOTE: Make sure the coolant is cold so you don't get scalded.


Does a 1986 Honda Accord Dx gas tank have a drain plug?

NO.


How do you change the coolant on 86 shadow 500?

To change the coolant on a 1986 Honda Shadow 500, start by ensuring the engine is cool, then place a drain pan under the water pump and radiator. Remove the drain plug from the water pump and the radiator cap to allow the old coolant to flow out completely. Once drained, replace the drain plug, and mix new coolant with water according to the manufacturer's specifications. Finally, fill the radiator with the new coolant mixture, replace the cap, and run the engine to circulate the coolant, checking for leaks.


How do you drain the radiator coolant on an 1986 Corvette?

there should be a pitcock on bottom of radiator to drain it. or take the bottom radiator hose with motor cold of course .


Where do you drain the engine oil for 1986 Honda 350 fourtrax 4x4?

into a form of containment unit


Is there a drain plug in the rear end of a 1986 Honda TRX 250?

yes there is it is a big nut on the rear of the rear end


1986 Honda Accord Overheating?

Check thermostat make sure fans work replace coolant easily done check manual


Where is the cooling fan switch located on a 1986 Honda CRX?

If you are talking about the coolant temperature switch that turns the fan on when the coolant reaches the right temperature, then mine it is located in the bottom of the radiator directly under the fan.


How do you remove thermostat housing from a 1986 Honda accord?

To remove the thermostat housing from a 1986 Honda Accord, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove any hoses connected to the thermostat housing. Unbolt the housing using the appropriate socket or wrench, and gently pry it off, taking care not to damage the gasket or mating surfaces. Clean the area before installing the new thermostat and housing.


What was the cost of a new Honda Accord in 1986?

the cost of the Honda accord in 1986 is $34995


1.5 fit in a 1986 Honda CRX?

The 1986 Honda CRX already has a 1.5.