answersLogoWhite

0

On the front side if the carb on the bottom

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Fuel to air mixture for a Honda ct 110?

Try 1.5 turns out on the mixture screw for an initial setting.


Where is the air fuel mixture screw located on a Honda VTX 1300 C?

On a Honda VTX 1300 C, the air-fuel mixture screw is typically located on the carburetor. Specifically, it can be found on the side of each carburetor body, often near the bottom. You may need to remove the air cleaner or other components for easier access. Adjusting this screw can help fine-tune the fuel mixture for optimal performance.


How do you set a jet of a Honda CRF R?

Turn the fuel screw all the way in, the turn it out two and a half turns. Turn the pilot air screw half a turn in to enrich the fuel mixture and keep it from stalling at low speeds if needed. If the fuel mixture is too lean then turn the fuel screw out a little, like a half turn.


What is adjustment for fuel on yamaha sh 50 scooter?

how to adjust air fuel mixture on yamaha sh50? Is the screw an air screw (in to richen) or a fuel screw? (out to richen)


What is the fuel-oil mixture on a 1984 Honda 250r?

The fuel-oil mixture for Honda 250r 1984 must be 2 percent of syntetic oil .


Is the Air fuel mixture screw on a 2004 TXR 90 Honda air or fuel screw And what is the factory setting?

Cant say from experience with this particular model whether it is an air or fuel screw, however; If there is only one screw then it does both. If there are 2 others near it then one does the air, the other two do the fuel. The factory standard setting for the main idle-adjustment screw on most bikes is 1 and 1half turns out from closed position. This is often the case with the other adjuster screws as well, but the mixture will need to be altered as the engine wears.


How do you adjust the air fuel mixture on a 2003 Yamaha YZ125?

torque specs air fuel mixture screw on a yz125 2003


How do you adjust idle on a Honda XR80?

Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.


Location of air fuel mixture screw on 1997 harley dyna-super glide?

Location of air fuel mixture screw on 1997 harley dyna-super glideRead more: Location_of_air_fuel_mixture_screw_on_1997_harley_dyna-super_glide


Fuel mixture ratio on 1986 Honda atc 200x three wheeler?

mix fuel honda atc 200x 1984


What is the fuel mixture for 1980 fl250 Honda odyssey ATV?

20:1 is what honda states


How do you adjust the carb on a Honda 300ex?

Only adjustment on it is the fuel mixture screw (on the bottom of carb) all the other jets are fixed, and the only way to modify is to buy new jets and install them.