0
the base idel screw in on the bottom of the throttle body.. there should be a cap over it
While there is a screw, it is more properly an idle stop screw, more than an idle adjustment screw; since the idle is controlled electronically by the SMEC (Single Module Engine Control) through the AIC (or AIS) valve mounted on the Throttle body. The screw that our friend refers to, is used in the factory to crack open the butterfly or throttle plate, but it should not be further adjusted. Instead, find the cause why Idle is not between 700-900 RPM. Possible causes are a dirty AIC valve, or an sticking one; or a wiring intermittent contact at the AIC valve connector; or a cracked insulation on the engine speed sensor, or even a failing throttle position sensor. Amclaussen.
What else can I help you with?
Does a 1997 dodge ram van 2500 have an idle screw and where is it?
Idle is computer controlled, there is no adjustment screw.
Why does my 1993 Dodge spirit idle rough?
I recently changed the E.G.R. valve on my 1990 Dodge Spirit 2.5L (non-turbo). Now it is quiet @ idle & starts right up. I also notice an improvement in the gas mileage. Good Luck.
Where is the idle adjustment on a 92 Dodge Caravan?
There is no adjustment screw, idle is automatically controlled by the pcm.
Where is idle screw on 2002 dodge caravan?
There isn't one. The idle is computer controlled and is not adjustable.
Where is the idle screw for a 1993 Mercury Tracer?
There is none. It is electronic. Try replacing the idle motor.
Where is the idle screw on a dodge stealth?
below the air intake on the throttle body
Why won't the idle speed adjustment screw on a 1993 mercury villager change the idle speed?
Idle speed is set by the PCM and is not adjustable. The screw you are fiddling with is just the stop screw to adjust the initial throttle plate position, it should not be used to attempt to adjust the idle.
How do you adjust the idle speed on a 1995 Dodge Neon?
Idle speed is controled by the computer. Unless there is a screw on the throttle body it is not adjustable.
Where is the idle adjustment screw located on a 1993 Ford Probe?
its located on the throttle body
Are there any idle adjustments for 1990 dodge spirit 2.5 engine?
No, the computer controlls that.
What should the rpms be at idle on a 1993 Chevy Camaro 3.4L V6?
between 500/750 depends on where the idle screw is set
How do you adjust the idle on a 1995 Dodge Ram?
To adjust the idle on a 1995 Dodge Ram, locate the throttle body and find the idle adjustment screw. Start the engine and let it warm up to operating temperature. Turn the idle screw clockwise to increase the idle speed or counterclockwise to decrease it, checking the RPMs with a tachometer as you adjust. Make sure to adjust it within the manufacturer's specified idle RPM range for optimal performance.
