To replace the ignition control unit in a 2000 Volvo S40, first disconnect the negative battery terminal to ensure safety. Locate the ignition control unit, typically found near the engine or under the dashboard, and remove the necessary bolts or screws to detach it. Disconnect the wiring harness from the old unit and connect it to the new ignition control unit. Finally, secure the new unit in place, reconnect the battery, and test the ignition system to ensure proper operation.
where is the ignition relay on a 1994 280 sl
My guess would be, Ignition Control Unit.
a control unit works by this other thing that makes it work but it also saves things.
The electronic ignition control module on an automobile is installed by first locating the unit at the top of the engine. The wiring harness is then disconnected from the original unit an a new module put in its place.
cbr125 has a clutch
70mph
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
it can go about 120
Bosch 0 227 100 018
If you meant Ignition control, that is usually behind the motor. This is just below your distributor where your plug wires meet.
12V