0
What else can I help you with?
What is the spark plug gap for a polaris 400 scrambler?
.028
What would cause a Polaris Scrambler to backfire?
my scrambler use to back fire i changed the spark plug and it never did it again
Where is the crankcase drain plug on a 2007 Polaris scrambler 500?
The crankcase drain plug on a 2007 Polaris scrambler 500 is hard to locate. However, it is behind the bolt in the skid plate.
What is the spark plug gap for 2002 polaris sportsman 500ho?
BKR6E plug with 0.035 gap.
What is the spark plug gap specs for a 1995 polaris xlt?
spark plug gap for polaris 425
Polaris 325 magnum 2002 spark plug gap?
I'm pretty sure it is .036>
What is the spark plug gap for a Polaris 750?
It is 0.028 in.
Why is your polaris scrambler transmission vent line blowing out transmission fluid?
If a Polaris Scrambler transmission vent line is blowing out transmission fluid the fluid may have been overfilled. Putting the transmission fluid in the wrong plug can also cause this.
What is the spark plug gap for a Polaris Indy 500?
The spark plug gap for a Polaris Indy 500 should be set between .025 and .028 inches. A new spark plug should need no adjustments as they come preset from the factory.
What is the spark plug gap on a polaris 400 ATV?
.028
How do you replace the spark plug on a 2004 Polaris Sportsman 700?
To replace the spark plug on a 2004 Polaris Sportsman 700, first, ensure the engine is cool and disconnect the spark plug wire. Use a socket wrench to remove the old spark plug by turning it counterclockwise. Before installing the new spark plug, check the gap and adjust if necessary. Finally, insert the new spark plug, tighten it securely, and reconnect the spark plug wire.
How do you remove spark plug on a polaris sportsman 400?
To remove the spark plug on a Polaris Sportsman 400, first ensure the engine is cool and the ignition is off. Locate the spark plug, which is typically found on the side of the engine, and disconnect the spark plug wire. Use a spark plug socket and ratchet to unscrew the spark plug by turning it counterclockwise. Once removed, inspect or replace as needed, and then reassemble by reversing the steps.
