On newer Sportsters the module is located under the battery. You have to remove the battery then pull up on the rectangular cover of the module on the bottom of the battery tray.
There is no flasher, it has a turn signal module under the seat, one bolt in the center holds a flat module, about 2 in by 3 in
npi
General Electric 199 C3
I have a 99 Sportser which should be the same. Mine just went out and it is located under the seat bolted to the rear fender.
try the headlight housing
The turn signal module on a 2008 Harley-Davidson Sportster XL is typically located under the seat. To access it, you'll need to remove the seat by unscrewing the bolts that secure it. Once the seat is off, you'll find the module mounted near the battery, usually connected to the wiring harness. If you're having trouble locating it, consult the owner's manual for specific diagrams and guidance.
The turn signal canceller P/N 68537-89(C) is zip ties to the right fork tube under the plastic triple tree cover.
On a 1999 Harley Davidson Ultra Classic, the turn signal module is typically located under the seat, mounted on the motorcycle's frame. To access it, you'll need to remove the seat by unscrewing the fasteners. Once the seat is off, you should see the module connected to the wiring harness. If you're having trouble locating it, refer to the owner’s manual for detailed guidance.
On a Harley Ultra Classic, the turn signal module is typically located under the seat or in the fender area. Specifically, it can often be found in the rear fender or near the tail light assembly. To access it, you may need to remove the seat or certain paneling. Always refer to the service manual for your specific model year for detailed instructions.
Under the seat. Between the battery and the fuel tank. Right under the slot your seat tongue slides into there is a larger hole in the frame...In that hole you see a silver box with a grey 8-place deutsch connector. You found the turn signal module
On a 1998 Harley-Davidson Fat Boy, the turn signal module is typically located under the seat. To access it, you’ll need to remove the seat and may also need to remove the side covers or other components depending on your bike's configuration. The module is usually housed within the wiring harness near the rear fender area. Always consult the service manual for specific details and guidance.
Remover the socket head cap screws from the fender struts and remover the tail light/ turn signal wiring from the tabs underneath the fender and you should be home free.