The timing hole for a 2001 Polaris Sportsman 500 HO 4x4 is located on the left side of the engine, near the engine case. To access it, you may need to remove the left side cover. This hole allows for alignment of the timing marks on the crankshaft and camshaft during maintenance or repair. Always consult the service manual for specific instructions and diagrams.
On the stator cover on the right side of the engine. Their will be a 9/16" bolt at the top of the housing, which is your timing hole.
roll engine over until the ( T ) mark is alighned in timing hole with piston to the top . adjust intake and exhaust to 0.15 mm or 0.006 in .
On my 2002 Sportsman 400 the drain plug is on the bottom of the transmission. It is in the large hole in the bottom of skid plate.
If your se is bad anti freeze will leak from the weep hole on the bottom side of the water pump cover really this is the only thing that will happen to the polaris twins
the hole is good
Locate the drain screw on the right of the transmission. Drain oil. Replace screw, then go to the left side and unscrew the fill screw and use a funnel to fill with Polaris tranny oil until its full to the screw hole.
no remove the air box and use open end 10mm. lower bolt will set in the hole when reinstalling no remove the air box and use open end 10mm. lower bolt will set in the hole when reinstalling. sand oxidized aluminum hole where starter goes into and coat with grease if having trouble getting it in place.
I believe the weep hole is the small hole in the bottom of the air breather box that has the rubber nipple on it. Not sure though.
Locate ur oil level stick follow it under the undercarriage and u will see a small Allen wrench nut remove it and ur oil will drain. Refill with a finely trough ur oil level stick hole. Only. Two quartsax
The Hole was released on 12/31/2001.
On a Honda 300 ATV, the timing hole is typically located on the left side of the engine, near the flywheel. It can usually be accessed by removing the left side cover or the timing inspection cover. This hole allows you to align the engine's timing mark when adjusting the timing or performing maintenance. Always refer to the specific service manual for your ATV model for precise instructions.
gear itself have a hole a bolt 8mm.x 2inch you align hole and tread you got it timing,dodong sabawsabaw ne.