0
What else can I help you with?
Which way do the nuts turn to take the blades off of a troy bilt pony riding lawn mower?
!st take off the deck and flip it over... then place a screwdriver through the hole next to the nut then righty tighty lefty losey
What are the blades of a lawnmower held by?
Blades of a lawnmower is held by nuts and bolts.
I have a Craftsman 15.5 OHV Kohler lawn tractor. The starter is good and has a new battery but will not turn over. I had been jump starting the tractor but now it will not start. What should I do?
Turn the key on, follow the red cable from the starter to the junction box make sure you have a rubber handle screwdriver and make contact with both nuts should turn over.
What animal will most likely be seen digging up or buring nuts in your lawn?
donkeys
How strong at the blades if you put nuts in the dough?
The blade is made from stainless steel,it is very strong and durable.
What are the exhaust manifold torque specs for 8n ford tractor?
55 On the Nuts And 70 no the cap screws Start in the middle and work out, maybe in 2 or 3 steps
How do you connect a battery on a tractor?
1. Locate the tractor battery cables. 2. Follow each cable to where it connects to the tractor. One cable will be connected/attached to the tractor chassis/frame. The other cable will be connected/attached to the tractor starter motor. If you don't find this to be true, then discontinue this procedure now. 3. Connect the unconnected end of the cable that is connected to the starter motor to the "+" or "pos" battery post. 4. Connect the unconnected end of the other cable that is connected to the tractor chassis/frame to the "-" or "neg" battery post. 5. Snugly tighten the post connector nuts to ensure a firm/stable electrical connection. Done. Your battery is now connected to your tractor properly.
Why is a squirrel digging holes in my lawn?
Squirrels dig holes in lawns to bury food, such as nuts or seeds, for later consumption. They do this as a way to store food for times when it may be scarce.
You would like to find a 445 Mouli Julienne?
A friend has one of these kitchen gadgets and I would like to know if you still make these its sort of a chopper for nuts or veg. and has several blades.
How do you change punto wiper motor?
Undo the 4 retain screws on the plastic at the bottom of the windscreen (do this with the bonnet open) Lift out the Plastic. Undo retaining points on motor and undo nuts on the bottom of the wiper blades. Remove blades and den lift out motor and linkage after disconnecting the wiring. Then reverse to replace :D
How do you level cutting deck on Murray model 46102X6B lawn tractor?
Make sure it is on level ground e.g. garage or flat driveway, make sure the tire air pressure is at 14psi. list cover on left side and move the deck all the way to bottom. Next loosen the 2 plastic wing nuts the deck will drop down, if not use your foot so it sits on ground. Next make sure both side measure the same or within 1/4 of an inch and re-tighten wing nuts, raise deck to desired level. make few passes if it cuts correct your finished, if not repeat again. May also need to replace wing nuts if they loosen to often. Hope this helped.
You are nuts you are nuts you are nuts?
You are dumbest
