answersLogoWhite

0

I am assuming that the mower doesn't start.... My first guess would be that you are not getting spark to ignite the gas in the engine. Check to see if you have spark at the spark plug.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you drain the oil kohler sears craftsman riding mower?

On a Kohler engine there is usually a drian plug on the left side of the engine (drivers side) near the rear of the engine. It is right in front of the oil filter. The oil filter base has a small plug in it that you will need to remove also to drain the filter base after you remove the oil filter.


Why does engine die after few minutes of operation on briggsstratton engine 2 cycle riding lawnmower?

It could be several things . The carb is not getting enough fuel or the ignition is shorting out when the engine gets hot . The fuel filter is plugged , the air filter is plugged .


Where is oil filter on yardman riding mower?

Many riding mower don't have oil filters. If your's does it is on the side of the engine toward the bottom and probably on the left side as you sit on the mower.


Does Briggs and stratton 2265X8c mower have an oil filter?

I need to know the engine size not the mower number to give you a definite answer. All B&S push mowers for the most part do not have an oil filter. All riding mowers with a B&S engine have an oil filter.


Does a Murray riding mower with a 12.5 hp have an oil filter?

Most Murray riding mowers with a 12.5 hp engine do not come equipped with an oil filter. Instead, they typically use a splash lubrication system that does not require a filter. However, it's essential to check the specific model's manual, as some variations may have different engine configurations. Regular oil changes are crucial to maintain the mower's performance.


How do you change the fuel filter on a riding lawn mower?

Slide the clamps down. pull the fuel filter off the hoses. Put the new one on. And look for for the arrow on the side of the fuel filter. The arrow is to show you which way the fuel is going. It comes from the fuel tank, and goes TO the engine. Point the arrow going to the engine.


What size battery does an MTD riding lawn mower use?

The battery size depends on the size of the engine. The larger the engine size the more cranking amps are required. A small 12.5 HP will only require around 190 amps while a 22HP will require closer to 360 amps.


What fuel filter does a Murray riding mower use?

Any inline fuel filter will work.


How do I find out why your riding mower blades will not turn?

Check the belt and if it isn't that, it could be the PTO. That's under the engine with two wires coming out of it. It will be in route with your blade belt


What filter does your sears riding mower take model 917289240?

The Sears riding mower model 917.289240 typically uses a replacement oil filter part number 591-446. For air filtration, it generally requires a foam pre-cleaner and a paper air filter, which can vary by specific engine type. It's always best to consult the owner's manual or check with a local dealer for the most accurate parts information.


Oil capacity for riding mower briggs-stratton engine 19.5 hp?

The book says for opposed engines without oil filter, it's approximately 1 & 1/2 quarts. If it does have an oil filter, then it's approximately 1 & 3/4 quarts.


How do you clean the carburetor cup on a craftsman LT 2000 17.5hp riding lawn mower?

To clean the carburetor cup on a Craftsman LT 2000 17.5hp riding lawn mower, first ensure the engine is off and cool. Remove the air filter cover and the air filter, then locate the carburetor. Use a socket or wrench to detach the carburetor bowl, and clean it with carburetor cleaner and a soft brush to remove any debris or buildup. Reassemble the parts, ensuring all connections are secure, and replace the air filter before starting the engine.