The main reason was to rubber-mount the drive train.Thus the hyme joints.
The similarities would be a shorter list. A Fatboy is a Softail and a Road King is a Touring bike. The frame is completely different. If you are talking about 99-newer then the motor is even different (the Softails have solid mount balanced 'B' motors and touring bikes and Dynas have rubber mounted motors).
A transmission mount, as its name implies, is a place for the transmission to mount to the vehicle. It is also used to dampen vibrations from the transmission.
Begin by loosening your 1991 Chevy Camaro transmission mount bolt. Jack the transmission up a few inches. Remove the transmission mount bolt and the transmission mount bushing. Put the new transmission mount bushing in and reverse the process.
Loosen the transmission mount retaining bolts. Loosen the back to engine retaining bolts. Jack the transmission of approximately 1 inch. Remove the transmission mount bolts. Remove the transmission mount. Reverse the process to install the new transmission mount.
a vibrating transmission could be caused by a bad transmission mount. If the mount breaks then the transmission will physically move causing it to vibrate.
It's a transmission mount.
The 1997 Chrysler Sebring transmission is equipped with two transmission mounts. There will be a transmission mount at the back of the transmission, on each side.
Loosen the rear transmission mount retaining bolt. Jack the transmission up a couple of inches. Remove the retaining bolt and the transmission mount.
It supports and holds the transmission in the vehicle from the underside of the transmission.
FXR=Harley-Davidson Super Glide motorcycle model
To change the transmission mount on a 1973 Super Beetle, first, safely lift and secure the vehicle. Remove the bolts securing the transmission to the mount, then support the transmission with a jack. Unbolt the old mount from the chassis and install the new mount in its place. Finally, reattach the transmission to the new mount and lower the vehicle, ensuring all bolts are tightened to the manufacturer's specifications.
on the transmission