answersLogoWhite

0

What else can I help you with?

Related Questions

How do you take off a lug nut off a weed eater?

With a wrench.


What is the best way to replace a weed eater cord?

The best way to replace a weed eater cord is to first make sure the engine is off and cool. Then, remove the spark plug wire to prevent accidental starts. Next, remove the spool housing and old cord. Install the new cord by winding it onto the spool in the correct direction. Finally, reassemble the weed eater and test the cord before using it.


When the fan starts on your computer it shuts the computer off?

Only if you shut it off. :)


How do you change the spool on a craftsman bushwacker weed eater?

I can't seem to get the spool off.


What is wrong if your car engine shuts off as soon as you start it?

1991 mitsubishi eclipse 2.0L starts 2 to 3 seconds later shuts off


How can I replace the string on a weed eater?

To replace the string on a weed eater, first, turn off the weed eater and disconnect the spark plug. Then, remove the spool housing and take out the old string. Cut a new piece of string to the appropriate length and thread it through the spool. Wind the string in the direction indicated on the spool and secure the ends. Finally, reassemble the spool housing and reconnect the spark plug before using the weed eater again.


How do you get the spool off a weed eater twist n edger TE 15?

The spool can be taken off a Weed Eater Twist N Edger TE 15 by pressing inward and turning it counter clockwise. This allows more cutting line to be added or jams to be cleared.


Car starts and then turns off?

96 olds 88 runs for 20-30minutes shuts off wait 10 minutes starts up


How do I perform a Ryobi weed eater string replacement?

To perform a Ryobi weed eater string replacement, first turn off the weed eater and disconnect the spark plug. Then, remove the spool cover and take out the old string spool. Cut a new piece of string to the appropriate length and thread it through the spool. Wind the string in the direction indicated on the spool and secure the ends. Finally, replace the spool back into the weed eater and reattach the spool cover.


How do you clean air filter on my weed eater lawnmower?

Take the air filter off and clean it then put it back


When you put a game in your ps3 it starts to load and then the pas3 just shuts off why?

cause it is broke


Your 1997 Monte Carlo LS starts for 10 seconds then shuts off the volts light is on but the car will restart and shuts off again after 10 seconds?

The alternator is most likely the problem