answersLogoWhite

0

Possibly the kill switch did not return to the 'on' position. On my 2003, you press the kill switch once for 'off' and the button stays 'in'. Press it again to return in to the 'out' or 'on' position. Sometimes it sticks in the 'in' position and will not start (starter will not turn over).

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Should the kill switch on a suzuki dr 125 be up or down?

up,that way when and if you crash you can get to the kill switch and shut off the bike.Hope this helps you out. rallyman7


How do you install a kill switch on a suzuki lt-r 450?

put a 3 prong -power - load - ground, switch on the (+) side of the coil .....


How do you reset oil change button on suzuki df40?

Change oil. Turn motor ignition switch to on but don't start Pull off emergency kill switch plate Pull emergency kill switch 3 times in less than 7 seconds. Replace kill switch plate. Done.


No spark 2001 suzuki rm250?

First make sure you have a good plug,if that is not it disconnect your kill switch, if that is not it, check your plug cap, then if that is not it go on to your stator.


How do you deactivate the kill switch in a 1998 Chrysler Sebring?

It does not have a kill switch.It does not have a kill switch.


How does a kill switch work?

The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.


Using Murray 12.5 hp 40 mower needed to get off When I tried to restart it not even turning over Bypassed the seat kill switch still nothing Jumped across solonoid turns over but doesn't start?

Did you raise the deck all the way up again after you got off? There is a safety switch on the deck handle, seat and clutch. When I got off the mower, I just put it in neutral and disengaged the blade. When I got up I knew the kill switch in the seat would turn it off, but though it would restart when I got back on and it didn't. -- My lawn was getting long, so I disconnected the kill switch wire from the ignition. Now, I can only kill the engine if I choke it out. I think the problem might be in the ignition switch.


How do you pull out the kill switch in a Chrysler 2004 Sebring sedan?

Chrysler does not have a kill switchChrysler does not have a kill switch


Where is the kill switch on a Jeep Cherokee?

It doesn't have a "kill" switch.


How do you replace kill switch on a 1998 Chrysler Concorde?

Chrysler vehicles do not have a kill switch.Chrysler vehicles do not have a kill switch.


Is there a kill switch on a 1998 dodge neon sport?

No, there is no kill switch except for the ignition switch.


Where is the kill switch located on a 1994 Taurus gl?

the kill switch?