take off the carbs and clean them out with come carb cleaner. Might be the choke cable sticking, or float bowls level is too high
My Yamaha Blaster stalls when I engage the throttle, what should I do?
Could be clutches or fuel. Make sure carbs are clean. Most problems come from dirty carbs.
Dirty Carberator. The needle vavle isn't letting enough gas in when you push the throttle and it is starving for gas and then kills.
Yamaha kodiak 400 starts then when u put it into gear and drive after a minite it reves up and stalls
take it to a mechanic?
Have you changed the main jet? Sounds like needle not seating fully or correctly.
If you are indoors get your emergency supplies ready. Turn on a battery powered radio for emergency information. If you are outdoors get to high ground. Avoid walking through flooded areas. If you are in a car and come to a flooded area, turn around and go a different way. If your call stalls, leave and go for higher grounds.
There is no specific collective noun for stalls, in which case a collective noun suitable for the circumstances is used, for example a row of stalls, a group of stalls, a bank of stalls.
In Singapore, Sarabat Stalls are stalls selling drinks particularly milk tea
It is a safety feature. You must pull in the left brake lever fully to engage reverse, if you try to put it into reverse without doing so, the engine will kill.
I asked this question before I signed in
You would need a lot more information than just a vague description of a single symptom to figure out what parts needed to be adjusted or replaced.