When the ABS and E-Brake dash lights illuminate together, it usually means that there is a loss of pressure. It's a fairly common problem on 4wd S-series vehicles (S-10, Sonoma, Blazer, Jimmy). It's best to have a dealership or qualified repair center diagnose the exact cause and make repairs.
Is the bulb burned out? Is the fuse for that side brake light good? If both answers are 'yes', then perhaps you should have an automotive electrical specialist check out the problem.
Check your tire pressure, check for wear on your front brakes, check for defective tire check steering parts may need front end alignment wheel bearing may need adjustment
The ABS (antilock brake system) light is on because there is a problem with the ABS system. Until that problem is fixed, the light will remain on and the ABS system will not be functioning. You will still have regular brakes but without the ABS function. Take it to a qualified mechanic for repair.
Usually this means that one of the wheel sensors has gone bad. A mechanic can scan the computer and tell which one it is. Your anti lock brakes will not work properly if you have to brake hard while the light is on.
It is located on a bracket about 8 or 9 inches above the pedal pad for the brakes...should have an electrical connector plugged into the back end of it. Pending on cruise control the assembly could be plastic or threaded metal as the switch body. Stu Louisville KY
It could be low on brake fluid, a sign of trouble. Have the brakes checked SOON!
If the ABS and brake light are coming on while driving, this is an indicator that it is time to get your brakes checked and replaced. If not, the brakes will wear out causing you to not be able to stop.
ABS means Anti-lock Brake System. If the light is staying on, you probably need to have your brakes checked.
Having the brake light on whilst driving means that your front brake pads are worn out and need to be replaced. Once you put new pads on it, the problem stops. It is a very quick thing to do and cheap as well.
Usually this a faulty signal light switch. The Signal light switch disconects the brake light on the signaling side and makes it flash.
it means get your brakes fixed xD
Well what do you know I solved the mystery mmyself it turns out after I paid to replace wheel cylinders and hoses and bleeding the brakes the cure was an $8.00 brake switch. Once I changed the switch the flashing brake light monster went away. So to anyone else who has a flashing brake light problem with your 89 Chevy S10 Blazer if you get a code 10 that is when the brake warning light flashes 10 times the fix is a new brake switch hope this helps someone.
If the brake light fuse is good and the brake light bulbs are good it's probably a faulty brake light switch.
Directly above the brake pedal.
Defective Master Cylinder or broken brake line. Replace the master cylinder and bleed the brakes.
Your brakes are failing
check fluid level