In case of 1phase
the reverse torque is obtained by reversing the current either in armature or field
DC Voltage
if you power an ac motor with dc or a dc motor with ac you will likely start smelling smoke and the motor will be damaged. If the motor is marked "3-phase", "shaded pole", or "induction" it is an ac motor! BTW, there are ac/dc motors that will run on both, they are wound very much like dc motors but a bit differently.
The easiest way would be to convert the AC power to DC by using a rectifier diode and a filter capacitor. In that way you can now run your DC motor on DC.
DC, in DC motor, is an acronym for Direct Current, which means that it works on direct electrical supply by a battery. In an AC motor, the motor runs on Alternating Current Supply from other sources other than batteries, such as electricity from your house.No, d.c. is not an acronym. It is simply an abbreviation."a word formed from the initial letters or syllables taken from a group of words"http://www.thefreedictionary.com/acronymYes, a word. "dc" is not a word.
A DC motor generates power when it is rotating even when no supply is connected.
e=mc2
Transistors are not normally connected to dc motors, but it is possible to use transistors in a speed-control mechanism for a motor.
This is when the rotor (Shaft of the motor) Stalls, normally due to overloading, bearing failure
the gear motor is normally worked by induction and DC motor the gears is the worked of change in motor function
yes. we can use...but normally generated power is Ac. so availability of dc is require a converter..
The Synchronous motors will operate at a constant speed from noload to fullload. Even it is classified as an AC motor, we have to fed the motor both AC and DC supplies. That we have to supply DC to the Field (Normally Rotor) and AC to the Armature (Normally Stator).
A DC shunt motor is a motor using DC supply with the the inductor connected parallel to the armature.
6V dc motor
A synchronous motor is an ac motor that does not run on dc.
In a dc motor, when the supply is suddenly turned off, there is a suddenly fall of speed in motor. this is reduced by means of electric effect. Hence it is called electric braking ( By @FarajAlyami electric motor braking has two types 1- electromechanical 2- electrical but electrical has some types as : 1- regenerative 2- dynamice 3- plugging ( counter - current )
Yes it can and the otherway aroud a DC motor can be used as a dynamo
A dc series motor can work on dc and ac because dc motors are totally reversible.