Never probe airbag wiring with a power probe or multi-meter unless you have isolated the circuit by disconnecting both the airbag module and airbag component. As long as you have disconnected these you will be fine.
The airbag light is warning you that something is wrong with the airbag system. In the event of an accident, they might not deploy, and you might get hurt or killed. Have a trained and qualified mechanic look at the system. It might be a simple problem.
Due to airbag considerations a rear-facing infant seat is absolutely NOT safe. A booster seat and child is fine. Airbag cannot be disabled
AnswerI had this problem on my '98 Plymouth Breeze. You can pull the fuse/relay and it will stop the horn but the problem is a short located on the airbag/horn button on the steering column. The airbag has plastic washers that wear out over time and allows the short to occur. The fix is to disconnect the battery, pull the airbag off and replace the plastic washers. BE VERY CAREFUL SINCE AN AIRBAG IS LIKE A MINI EXPLOSIVE DEVICE.
The passenger airbag on a Mitsubishi L200 can easily be deactivated by flipping the switch located in the glove box. This feature is available to allow a rearward-facing child restraint to be used in that seat.
Factory Floor with Marshall Brain - 2008 Frozen Pizza Multi-Tool Wool Airbag was released on: USA: 18 December 2008
inflatable resistance is the systems way of telling you that your airbag is functional this light or message should go out in a few seconds if the airbag system is operational , and working propperly if this does not go out then you need to have the airbag serviced
Drivers side air bag circuit low resistance or shorted
It might be a problem with the "clock spring".
Passenger side air bag circuit low resistance or shorted
Take a flat screwdriver, there is 2 holes on steering wheel one on each side, push the screwdriver in till you gonna feel resistance at the same time pull the airbag do the same thing with the other side. After the front is released pull the airbag it will come out.
There are a number of reasons why your airbag light has come on or is flashing. We will cover a few explanations that may help you identify where the problem may have originated from. First and foremost if the airbag light is on or flashing, the SRS system is inactive. Therefore, if you get into an accident, the airbag/s will not deploy leaving you unprotected. As you read through the information below suggestions will be provided that may help you solve your airbag light problem.Airbag Battery Backup DepletedA common problem that signals an airbag warning light to turn on or flash, is that your cars battery might have drained recently and the airbag battery backup depleted. This will often correct itself once the battery charge is fully restored. However, depending on your vehicle, you may need a scan tool remove the soft code error that was written to the airbag control module. Airbag Clock Spring Needs ReplacingThe airbag clock spring main function is to maintain continuity with the drivers airbag and the electrical wiring. It maintains continuity by coiling in and out as the steering wheel turns. After many years of use the thin circuit bands my become brittle or worn and cause the drivers airbag to have an intermittent connection. If this occurs a DTC soft code or will be reported to the airbag control module and the airbag warning light will turn on or flash. This is a popular problem on older model vehicles. The only way to determine if your clock-spring is damaged is to have a repair shop diagnose your airbag warning light with a scan-tool. The scan-tool will provide the technician with a DTC code and advise him if the the clock-spring needs replacement. Airbag Module Got Wet or CorrodedA common location for the airbag module in many vehicles is underneath the driver or passenger seat. Therefore, even in light water damaged vehicles the module will short-out or corrode after being exposed to moisture. A shorted module will immediately general a DTC airbag code and your airbag light will flash a warning. The water damaged modules should be replaced as they will often produce unexplained and continued errors.
Your computer cannot detect an airbag where it should be. This could mean that it has fired, is missing, or that the connection has been lost.
Airbag was created in 1973.
The spiral cable is located on the steering column, behind the steering wheel. It allows electrical continuity to the airbag and horn button while still allowing the steering wheel to be turned. Removal or replacement of the spiral cable assembly requires removal of the airbag. THIS CAN BE VERY DANGEROUS if not performed correctly!! Have a professional automotive technician perform this task.
The airbag system has a malfunction and will not deploy if needed as long as the airbag symbol stays on.
Can't find " 47 " on my list but air bag code " 74 " is ( Intermittent or Repaired Driver Side Air Bag Circuit Low Resistance or Shorted )
where is airbag module 98tacoma