answersLogoWhite

0


Best Answer

The passenger airbag on a Mitsubishi L200 can easily be deactivated by flipping the switch located in the glove box. This feature is available to allow a rearward-facing child restraint to be used in that seat.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Disarm passenger airbag in Mitsubishi l200?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Movies & Television

Why are my Dash lights out temp and fuel gauges not working and dome light out and wont shift out of park but the car runs it is a 2001 Saturn L200?

Check all fuses- many unrelated problemsCheck wiring to fuse boxCheck for loose ground Stop lights and shift interlock should be common circuitDash lights parking/tailights should be common circuit


Why do the head lights dash lights turn off and on and the security light come on when a Saturn l 200 has been running for an hour or more?

I do not have an answer, but I do have the same problem as you do. I have a 2001 L200, and from the moment you start the engine, every few seconds, the security light will flash and the temperature and gas gauge needles will act as if you turned off the car, and then pop back up where they should be. When the headlights are on, the dash lights will flash along with the security light and the gauges. The headlights and radio are not affected, though. In addition to that, the odometer has also stopped working. It has read the same milage since I noticed some time ago. I will let you know if I find out anything.


How do you fix windshield wipers on a 2002 Saturn L200?

You need to purchase a new motor. You can purchase one at a dealer, a parts store, or even a junk yard if you get lucky. If you don't know how to fix this yourself you should take it into the shop to have it done properly, and if you still have a warranty the dealership should be able to get you into their service department. Good luck. There are two screws under the dashboard top plate, and two nuts at the windshild wiper post. That's only if you want to do it yourself. put 'masking' tape on both sides of you present wiper positions. About 2 hours. Care on the screws that hold the dash plate should be observed. It's plastic and fragile.


Why would your hazards not work if all fuses work and flashers have been replaced turn signal lights work?

The relay that handles the turn signals is separate from the relay that handles the hazards. Most likely you have a burned out turn signal relay. Most likely the relay is located in your fuse panel and is a very inexpensive item to replace. turn signals and hazards have separate flasher cans both look the same and are generally in the fuse box replace the hazard flasher can. they cost about 2 dollars at auto store HOUNDDAWG ADDS: There may be a lamp with one of the turn signal elements burned out. If one is burned out turn signals may not work even though the lamp appears to be working when the lights are on. Otherwise replace emergency flasher or possibly turn signal switch in steering wheel. gaffer0118 adds: I had the same problem on my 2003 Saturn L200. When I cycled the Hazard Signal/switch for about 30 seconds, both left and right turn signals once again worked!!