Yes. The 250 voltage is a not-to-exceed rating.
230 V @ 50 Hz (like most of western Europe and the middle east).
Some flat irons won't work in Europe, even with an adaptor. The voltage is too high, and if your flat iron doesn't have the voltage conversion number listed on it, then you can't use an adaptor. For instance, on some hair dryers it might say 125-250V. That tells you it will convert itself to use less power when you plug it in to an adaptor. But many flat irons only say 120V, and that tells you it will not be able to be used with an adaptor. I would suggest purchasing a new flat iron, one that has the ability to to use less voltage, or buy one with a European plug. That's what I did when I traveled to Italy.
ST22 SeriesThermal Protectors  Features Bimetallic Thermostat Positive snap acting Superior heat responseW Type Automatic resetting High grade thermoplastic insulated case  Applications Motor, transformer, batteries, electronic circuits, solenoid, electronic appliance etc..  Specifications Operating temp. range: from 70℃ to 150℃ Tolerance: +/-5℃ Differential: 30+/-15KDimensions(mm) Contact capacity: 50mA/repeatedly, Max current 30A/5 cycles Electricting Rating: AC 125V/8A, AC 150V/5A(Resistive load) AC 125V/3A, AC 250V/2A(Inductive load at 50% of power factor)
250v On an automotive battery it is 2.2V
nope
For a cooker hood, it's essential to use a capacitor that matches the specifications of the motor. Typically, a capacitor rated between 1 to 10 µF (microfarads) with a voltage rating of at least 250V AC is suitable. Ensure it is a run capacitor, as these are designed for continuous use in appliances like cooker hoods. Always check the manufacturer's guidelines for the exact specifications required for your specific model.
No
No, it is not safe to plug a device rated for 250V into a 110V outlet. The device may not function properly and could potentially cause damage or pose a safety hazard. It is important to always match the voltage requirements of the device with the power source.
T= timedelay 800= ? L=? 250V= volts
The current rating is 2A (2 amps).
Üretici: WickmannParça Numarası: F6.3H250VAmper: 6.3Voltaj: 250Malzeme: Seramik
yes
Divide the watts by the voltage to get current (amps). 60W / 250V = about 1/4 Amp.
No, the amperage pin configurations are different between a 15 amp and a 30 amp plug.
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.