The cable voltage is set by the voltage of the supply and not by what is connected to it. But a 100 watt amplifier on a 120 v supply would draw less than 1 amp even at high volume.
a 100 watt bayonet
40W Bulb will spiol due to over current passing through its coilAnswerSince the 40-W lamp has a higher resistance than the 100-W lamp, the greater voltage drop will appear the 40 W lamp. As a result the 40 W lamp will be subjected to a voltage beyond its 100-V rating, and the 100-W lamp will be subjected to a voltage below its 100-V rating. Therefore, the 40-W lamp will burn much more brightly than the 100-W lamp.Incidentally, the symbols for the 'watt' and 'volt' are upper, not lower, case: W and V.
The answer is "It Depends" Watts of electircal power is defined as Voltage x Current. Amperage is a unit of current. In most houses in the US the voltage is 120 volts AC. A 100 watt light bulb in the house would have 120 volts across it so the current flowing would be: Watts = Volts x Amps 100 watts = 120 volts x I amps A amps = 100 watts / 120 volts A amps = 5/6 amps ANSWER watts is a product of voltage and current .One quantity will never suffice
the actual filament itself in a light bulb has the most resistance,this is why it glows and produces light,the rest of the bulb is sufficiently engineered to carry the voltage and current applied to it without producing too much heat.
One joule is the amount of energy required to apply a force of one newton through a distance of one meter (one newton-meter), or it is the amount of energy required to produce one watt of power for one second (one watt-second).If we assume that you have a mass of 200 pounds or 91 kilograms, then it requires a force of 891 newtons (91 * 9.82) to support you. This force will be the same whether you are standing still or climbing, even though it will momentarily change when you accelerate, so we can use 891 newtons.If we then assume that a flight of stairs is about 3 meters, we can calculate the power to climb up at 891 * 3 = 2672 joules per flight.Lets look at the light bulb. That one is easy. 100 watts is 100 joules per second.Now the question is, how fast can you climb? Let assume 10 seconds per flight of stairs. That translates to 267 joules per second, so you use nearly three times the energy of a 100 watt light bulb to climb stairs. (Two times, if you climb a little bit slower.)
It depends......perhaps 7400 to 8500 initial lumens degrading to 5400 lumens.
The main difference between a 100-watt and a 75-watt light bulb is the amount of light output they produce. A 100-watt bulb will be brighter and consume more energy compared to a 75-watt bulb. The 100-watt bulb may also generate more heat than the 75-watt bulb.
bright light
A 100 watt bulb typically draws around 833 milliamps (mA) of current. This calculation is done using Ohm's Law formula: Current (I) = Power (P) / Voltage (V). With a standard 120V power source, a 100W bulb would draw approximately 833mA.
Yes, a 100 watt bulb produces more heat than a 25 watt bulb because the higher the wattage, the more energy is being converted into heat. In this case, the 100 watt bulb will generate more heat compared to the 25 watt bulb.
The voltage isn't decided by the lamp, but by the supply the lamp is hooked up to.
The more energy that is transferred in a certain time, the greater the power. A 100W light bulb transfers more electrical energy each second than a 60W light bulb.The equation below shows the relationship between power, potential difference (voltage) and current:power (watts) = current (amps) x potential difference (volts)
If it's a 100 W bulb that does not say everything about it. It could be a 12 v, 24 v, 120 v or a 230 v bulb, or other voltage. Look on the case or the packet.
The brightness level of a 25 watt LED bulb is equivalent to that of a 100 watt incandescent bulb.
A 40 watt bulb is dimmer than a 100 watt bulb.
A 1,000 watt is 15,000 lumens. A 100 watt bulb is 1,500 lumens.
100