resistor
as the name suggest transistor means to transfer resistor, it is an electronic device,
A fractor is a circuit component that has both the function of resistor and capacitor.
When it is connected to resistor
when we replace the resistor with a capacitor ,the current will flow until the capacitor charge when capacitor will fully charged there is no current through the circuit because now capacitor will act like an open circuit. for more info plz E-mailt me at "zaib.zafar@yahoo.com"
Where you are measuring. A simple filter will be two elements - a capacitor or inductor and a resistor. A capacitor will tend to "trap" low frequencies. In the case of a lowpass filter made of a capacitor and resistor, the output voltage will be measured across the capacitor. Inductors are the opposite, so the output would be across the resistor.
A transistor acts like a resistor when Gate is connected to Source.
1)Transistors 2)Capacitors 3)Resistors
capacitor,transistor,resistor,inductor
Transistor Diode Resistor Capacitor
A: A TRANSISTOR gain is determined by current flow on the collector by adding a resistor to the emitter this current flow is reduced by adding or bypassing this resistor with a capacitor the net effect is that this emitter resistor will be reduced in value as frequency increases therefore change gain as a function of frequency input
A common-emitter (CE) transistor amplifier circuit typically includes a NPN transistor, a biasing resistor network, an input coupling capacitor, and an output coupling capacitor. The input signal is fed into the base of the transistor through the coupling capacitor, while the collector is connected to a power supply through a load resistor. The emitter is usually grounded or connected to a resistor. This configuration allows for voltage amplification, where the output is taken from the collector.
astable multivibrator type transistor is free running oscillator.so it has greater stablity . it can be varied by resistor and capacitor value
as the name suggest transistor means to transfer resistor, it is an electronic device,
the capacitor and its associated resistor set the time constant.
need to use BC107 transistor which has three terminals base, collector and emitter........ collector is connected with 6.8k ohm resistor other end of this resistor is connected with 3.7 ohm resistor and it is connected to the base of the transistor which is already connected to a capacitor of 1 micro F and a positive of function generator......and in the output side i.e in the collector and emitter side connect the 1 micro F capacitor and 10 kohm resistor and connect the CRO...... then other to the ground.......
A fractor is a circuit component that has both the function of resistor and capacitor.
A fractor is a circuit component that has both the function of resistor and capacitor.