0
What else can I help you with?
How do you hook up a PS3 to a trinitron tv?
how to hook a playstation3 on a sony trinitron
How do you calculate AC load from DC load?
Amp measurement in a dc circuit is commonly done by use of a clamp on amp meter. The meter has a loop on one end that opens up. The loop is clamped around a wire, and the meter shows the amperage.
How do you hook up VCR to projector?
you will need to hook a/v cables to from the back of the vcr to the projector.
Did derwin and deon hook up?
yes
How do you hook up 2 capacitor?
Depends if it is for a amplifier it goes inline.Take the + side on the cap and hook the same positive wire that runs to amp and just ground the - of cap to chassis ground.For instance say u have your positive wire ran well just cut in into where u want the cap and place ring terminals on each end of cut wire then place them on + side of cap.The closer to amp the better.then just ground your cap.Remember caps don't make your alternator bigger just adds more strain to and under powered alternator
How do you hook up particular DC amp meter?
idont know may be you should to give me answer about ; why the adventure exciting? p.s give answer...
Can you hook up a clamp amp meter the wrong way?
Yes, you can hook up a clamp amp meter incorrectly, but it typically won't cause damage to the meter. If the meter is placed around the wrong conductor or if it is reversed, it may display a negative reading or zero current. Always ensure the clamp is positioned correctly around the conductor you intend to measure to obtain accurate readings.
When hooking up an amp and speakers do you wire the speakers through the stereo or the amp?
Hook your speakers up to the amp.
How do you hook up an vr3 200 watt 2 channel amp to a car stereo?
well you hook it up
How do you hook up a stereo equalizer?
Put the E.Q. between the pre amp and the main amp.
Your amp cuts off when you hook it up to your subwoofers?
either your amp has a short..... or.... you have a bad ground
How do you hook up a sub-woofer and amp?
Try the related link:
How do i wire a toggle switch for an amp?
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
How do you insall a amplifier?
hook a ground up to your battery and mount it to the amp and hook it up with a few more things and yea you got it man
Can you hook a car subwoofer to a DJ amp?
Yes you can hook up a car subwoofer to a dj amp. Some dj amps have a barewire hook up on them so you can hook it up using the same wires as you would with your car amp. If not then you would have to either convert your hook up on the speaker box to the style in which your amp takes, or splice new ends onto your existing wires to hook up to the amp. The one thing to watch out for is your rms and peak power. Dj amps tend to be a bit more powerful then car amps and you can cause damage to your speaker and or amp by forcing to much power, or by giving to little power. I suggest trying it out at home for a good amount of time on a med. power level to see if the amp and speaker can hold to a couple hours of non stop use before I would take it to a gig with me.
Can you hook up amp and sub to 1997 park avenue?
Sure. You can hook this up to any vehicle. It is easy to do. Just make sure you have the proper gage wire for the amp as a small gage wire can heat up. Also with a smaller gage wire you will lose some power to the amp.
Can you hook up one subwoofer to a 2 channel amp?
uhhh noo
