It depends on which switch you are talking about.If you are talking about the door ajar awitch you need to remove the interior door panl along with the shower curtain.After that it will be best to remove the door lock,latch to get to the door ajar switch.This switch usually comes off with a push in and a turn in the counter clock direction.Once this is done just put all back the way you took it off.I assume that this is what you are talking about, however there are other switches,Window,lock,mirror, window lock and sometimes more.
If the lock switch is set to unlocked and it will not open from the inside or outside, the door lock arm may have fallen lose. Take the inside door panel off and check around the door levers and door lock.
Oh, dude, the interlock monitor switch in a microwave oven is basically the bouncer at the club, making sure the door is closed before the party starts. It's there to ensure the microwave only runs when the door is properly shut, so you don't accidentally nuke your hand while trying to make popcorn. Like, safety first, right?
replace the door switch. its most likely bad
it is inside the door panel
The door switch for the VW Polo can go bad and cause the interior light to stay on. The switch must be changed, there is no way to repair it.
To replace the switch, no you don't have to remove the door panel. There should be 2 screws holding it in, both right on the switch mount.
The door switch, (a little push button on the wall that the door smacks against, is probably stuck. But they are a pain to replace.
Yes
yes they will 100% sure
Door Switch Fault You may find the door-switch is the problem, it is quite common on that model and age, the door hinges wear and the door drops, so the switch is not being pushed in fully, which would break the circuit and put the light out, [try adjusting the door to make it fit better, or replace the hinges], [the switch may be loose or broken], [there is one switch on each door].
Pull the door panel off, remove the door latch assembly from inside the door, and replace the switch which is hold onto the latch with one screw on the backside of the latch.
It is possible that the door jamb switch is weak. Starting with the drivers door, wiggle the switch and then close the door; if this helps to shut off the light ,replace the switch.
== ==
You remove the wire cluster then unbolt the hinges from the frame, leaving them on the door.
Once the door panel has been removed, it should be pretty evident how the switch mounts to the panel itself.See "Related Questions" below for lots of information on removing the door panel...
how do you replace a blend air door assembly on a 2000 pontiac bonneville
Check and possibly replace door hinges