it talls u
, If the battery has no markings then you should be able to tell from the sides. The flat end is the negative which pushes down on the spring, and the side with the bit sticking out is the positive which slots in nicely :) hope i helped :) x
Hook up the jumper cables in this order: (1,2,3,4) (1) One end of positive cable to positive post of GOOD battery (2) Opposite end of positive cable to positive post of DEAD/LOW battery of disabled vehicle (3) One end of negative cable to negative post of GOOD battery (4) Opposite end of negative cable to GROUND on disabled vehicle (a good ground is preferred over the negative post, however, the cable can also be hooked to the the battery post). To remove the jumper cables after starting, reverse the order (4,3,2,1)
No. Electrons are not consumed in a battery. For every electron that goes in one end of a battery, the battery pushes another electron out the other end.
To get 24V from 2 12 V battery's Yo hook up the positive pole + of one of the battery's to the negative pole - of the other one. you will be left with a positive pole on each battery wit no connection on them The voltage between them is 24. If you want the battery to have the same voltage but have more amperage you connect positive to positive and negative to negative.
Yes you can. Connect the chargers positive lead to the positive of one battery, then the negative side of that battery to the positive side of the other battery, then connect the negative lead of the charger to the negative of the second battery. Double check all your connections and turn on the charger.
The positive end of a battery goes to the positive end of the terminal. In retro spec, the negative end of a battery goes to the negative end of the terminal.
The positive terminal of a battery is typically located at the end with a plus sign () symbol.
If the battery has round terminals the positive is the larger diameter of the two
The flat smooth end is negative. The end with the small bump in the center is positive.
Its an anode
Yes [[+ -]l
It is normally red.
Well the flat of the battery is the negative side.
When jumping two automotive batteries, connect the positive () cable to the positive terminal of the dead battery and the other end to the positive terminal of the live battery. Then, connect the negative (-) cable to the negative terminal of the live battery and the other end to a metal surface on the car with the dead battery, away from the battery.
The top of a battery is called a carbon rod, which is on the positive terminal.
If you have a post battery(the cable attaches from the top) the positive post is larger than the negative.
I can't tell you precisely on your model, but if you follow the positive (red) battery cable down from the battery, it should connect to one end of the starter. Hope that helps a little.