This is 220 volts AC, I assume. 10 x 220 = 2.2kVA of power. The real power will depend on the power factor. Take the power factor times 2,200 to find the watts.
4 volts and how many amps? Watts = amps x volts. It depends on the amount of current (in Amps) flowing at 4 Volts... See Ohms Law: Watts = Volts x Amps If you have 2 Amps flowing at 4 Volts you are dissipating/consuming 8 Watts. If you have 10 Amps flowing at 4 Volts you are dissipating/consuming 40 Watts.
That depends on circuit voltage. 1 watt is equal to 1 volt times 1 amp.
The same number as 250 oranges is apples. A watt is a volt times an ampere.
W = A x V. Watts = Amps x Volts. There is not a voltage stated to multiply the 6 amps with so an answer can not be given.
Watts is the product of amps x volts. To give an answer the amperage needs to be given.
watts = volts * amps--> Amps = watts/ volts therefore; 2000/220= 9.09 amps
The formula you are looking for is I = W/E. Amps = Watts/Volts.
Watts/volts = amps3000 / 220 = 13.6363 Approximately.
First you need to find out how many amps the heater draws. Then use this formula: Volts (220) X Amps = Watts Then take: Watts x 3.41214 = Btu/hr
To calculate the amperage, you can use the formula A = W / V, where A is amperage, W is watts, and V is voltage. Thus, for 4800 watts at 220 volts, the amperage would be 21.82 amps.
Watts = volts x amps x power factor Power Factor is 1 for resistive loads and decreases for other loads like motors. Maximum watts would be 12 x 220
The equation that you are looking for is I = W/E. Amps = Watts / Volts.
That of course depends on who made the water heater and what model number it is you could always call the manufacturer. Quickest way I know of is to look at the heating elements. They will have a wattage rating. This number is visible when you take the cover or covers off, move aside the insulation and use a flashlite to spy the pesky little rascals.I suggest you shut off the voltage first. My 80 gal has 2 elements of 4500 watts each if I'm not mistaken. All you need to do is multiply the Volts by the Amps and that equals watts
If you are asking about 220 watts, remember Watts equal power, which is Volts times Amps. Amps are used to measure current - how many electrons flow past a certain point per second - so there is no answer to this question. If you meant to ask what current a load of 220 Watts would take if the applied voltage was 110 Volts, the answer is 220 Watts divided by 110 Volts = 2 Amps.
This depends on the voltage ... amps = watts / volts 660 W / 110 V = 6 amps 660 W / 220 V = 3 amps 660 W / 330 KV = 2 mA
The formula you are looking for is I = W/E. Amps = Watts/Volts.
You cannot convert 2.6 kw to amps with that information only. In order to convert watts to amps, you also need to know either current or voltage. This is because watts is volts times amps, and volts is current times resistance