Ohm's law: Volts = Amps * Ohms, or Amps = Volts / Ohms 12 volts / 0.5 ohms = 24 amps
That depends on circuit voltage. 1 watt is equal to 1 volt times 1 amp.
Ohm's Law: Voltage = Amperes times Resistance 9 volts = amps * 10 ohms amps = .9
For a single phase circuit, the equation you are looking for is I = W/E. Amps = Watts/Volts.
"Volts" is electrical pressure applied to a circuit; whereas, "ohms" is electrical resistance to that pressure. One cannot determine ohms from voltage without knowing either the current (in "amps") or power (in "watts"). A normal 120V household circuit can handle a maximum of 20 amps, so using ohm's law of resistance = voltage / current, the minimum resistance required in a 120V household circuit would be 6 ohms. Any less than 6 ohms will cause the circuit breaker to trip.
4 volts and how many amps? Watts = amps x volts. It depends on the amount of current (in Amps) flowing at 4 Volts... See Ohms Law: Watts = Volts x Amps If you have 2 Amps flowing at 4 Volts you are dissipating/consuming 8 Watts. If you have 10 Amps flowing at 4 Volts you are dissipating/consuming 40 Watts.
Watts is a power level, not a voltage. The wattage in a circuit is defined as Volts x Amps, so you need to know the current before you can work out the voltage.
In a Direct Current circuit power is equal to the product of current times voltage or in another form of the same equation, power divided by voltage equals current in amps. 280 watts divided by 24 volts equals 11.6666666 amps.
It depends on how many Amps (current) are applied to the voltage. Watt = Volts x Amps. e.g. 12 volts @ 5 amps = 60 watts
That depends on circuit voltage. 1 watt is equal to 1 volt times 1 amp.
Amps can not give you a kilowatt with out a voltage being applied to the question. Watts = Amps x Volts. Amps = 1000/ Volts.
To answer this you have to know how many volts will be used. If you know the voltage then you can calculate the current by dividing voltage into wattage. For example; an electric heater rated at 700 watts when plugged into a 115 v outlet will draw 700/115 = 6.08 amps of current.
Depends on the voltage. Watts are volts x amps.
It depends on how many Amps (current) are applied to the voltage. Watt = Volts x Amps. e.g. 12 volts @ 5 amps = 60 watts
That depends on the voltage, but the residential standard is 240 volt. At that voltage you sit at around 15 amps, however it MUST be on a 20 amp circuit for national (US) or Canadian electrical code, as you can only load your circuit to 80% of it's capacity.
The terminal strip's rating is 15 amps at 600 volts. It does not matter what the voltage is up to 600 volts, the maximum amperage allowed on the strip is 15 amps. It could be 15 amps at 12 volts or 15 amps at 600 volts or any voltage in between.
One Megawatt = 1,000,000 watts. Watts = Volts x Amps or voltage x current. Hence if you know the voltage then Amps = 1,000,000 watts / Volts.
The equation that you are looking for is I = E/R. Amps = Volts/Resistance.