The power supply is probably defective. If it isn't a year old, they will fix or replace it at no charge.
I am answering my question to help others. The flasher unit was not working. It is located at the driver's left knee. This is to the right of the fuse box next to the blue relay. You have to remove the bottom panel to get to it. There are two Philip screws, you have to pull it down and out of its snaps. I plugged in the new relay and everything is working now.
CHECK THE FUSE PANEL DASH & TAIL LIGHTS WORK FROM SAME FUSE
The tow bar comes with a color coded wiring harness. The tail lights, blinkers, and brake lights are hooked up to a terminal near the trailer hitch of the towing vehicle and then the tow lights are plugged into the socket for the car lights. There are four wires. The brown is the brake lights, the green and black are blinker lights, and the white wire is the ground wire.
There is a wire harness. The bulbs tend to go out.
Check grounding wire's then use a test light
Well if the lights were outdoor Christmas lights that shouldn't happen. Although if one of the wires connecting to the lights was damaged in some way, then all the lights would most probably fail to work.
signal lights not working.
Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.
It is possible the antenna is bad but it is probably the receiver that has gone out. The receiver is under the dash, above the gas pedal, behind the ash tray. It is silver with wires and the antenna plugged into it. They are getting harder to find for a reasonable price.
If a Passat 04 TDI's indicator lights are not working, check the fuse. A blown fuse can cause the lights to stop working.
Yes and it could start a fire.
Yes, night lights that are plugged in but not turned on still use a small amount of electricity, referred to as standby power. It is often recommended to unplug devices when not in use to save energy and reduce electricity consumption.
To install Christmas lights for the holiday season, first untangle the lights and check for any broken bulbs. Next, plan where you want to hang the lights and make sure you have enough extension cords and clips. Then, start at the top of your house or tree and work your way down, securing the lights with clips or hooks. Finally, plug in the lights to make sure they are working properly before finishing the installation.
crown Victoria blower not working and head lights.
my lights are not working when i changed the pads on my peutgeo partner van
My dad created a parallel circuit when he plugged in the Christmas lights.
I did this last year for about 6 days and it worked wonderfully. Most gas central heater are 110 and the easy way (wich is what I did) was to locate my furnace. It was plugged into an outlet just like any other appliance. I simply plugged it into a medium duty extension cord and plugged the cord into the generator. The generator was a 3500watt and ran my CH&A, TV, Surround Sound, lights and 2 refrigerators. We also cooked on a George Forman. Hope this helps.