If you have a 4.3 vortec,
Locate and open radiator drain plug into container. (apx 3 gallons) Remember antifreeze is posion!!! Remove radiator cap. Loosen intake hose clamp, Loosen the two wing nuts on the plastic part of the air intake atached to the top of the radiator and remove. Loosen the radiator clamps and remove the hoses from the radiator. Loosen the two transmission lines.(DO NOT BEND if possible) Remove the two bolted clamps on the top. Carefully lift straight up and out.
When replacing, be carefull not to cross-thread the transmission lines.
Late Night with Conan O'Brien - 1993 1993-11-10 was released on: USA: 10 November 1993
yes at 1993 Feb 10
Late Night with Conan O'Brien - 1993 1993-10-15 was released on: USA: 15 October 1993
Late Night with Conan O'Brien - 1993 1993-10-05 was released on: USA: 5 October 1993
Late Night with Conan O'Brien - 1993 1993-10-22 was released on: USA: 22 October 1993
Should be at the bottom or rear of radiator
Spark Plug Gap 1993 4.3.035 hi i have a 1993 blazer 4.3 the gap four that is 0.045
knock sensor
the delership or library
That would be 5300#
Front center of radiator support.
Where can i find a serpentine belt diagram for a 1993 s-10 chevrolet blaze?
Need to know what year S-10 you have.
Most thermostats are in-line with the upper radiator hose. Check the housing where the upper radiator hose connects to the block.
I have 20" Dayton wires on my 84 s-10 4x4 blazer with 225x50x20 and it rideas fine. I have 20" Dayton wires on my 84 s-10 4x4 blazer with 225x50x20 and it rideas fine.
0 before top dead center.
i think its right on the front of the motor just behind the idler pully. At least it is on my 96 chev blazer.