TTL is faster and does not lose amplitude
TTL (Transistor-Transistor Logic) inputs typically refer to the number of inputs that a TTL device, such as a logic gate or flip-flop, can handle. Common TTL logic gates often have 2 to 4 inputs, while more complex devices like multiplexers or encoders can have larger numbers of inputs, ranging from 4 to 16 or more. The specific number of TTL inputs depends on the type and design of the device in question.
true and false
A digital circuit composed of bipolar junction transistors (BJTs). Widely used in all variety of electronic applications, especially prior to CMOS circuits becoming popular, TTL superseded the earlier RTL (resistor-transistor) and DTL (diode-transistor) logic designs, which used more power. In TTL, transistors are used to both isolate inputs and perform the logic switching. A "TTL" designation on a circuit input or output indicates a digital circuit rather than analog.Read more: transistor-transistor-logic-electronics
Unused ttl inputs would normally default to logic 1 if left floating. but these inputs could act as antennas under certain conditions and they could pick up noise which can cause the circuit to malfunction.
ECL or emitter coupled logic is faster than TTL type logic because the switching transistors do NOT go into saturation in either the on or off state. The switching time from saturation in a high output to saturation in a low state like TTL requires that the junction capacitance be overcome and that the charge in the saturated junction get swept out. ECL is sensitive to a threshold level only.
DRL cannot invert signals.
TTL is a logic family. A logic family is the set of logic gates designed using a specific approach. Or simply speaking, logic family is the way of implementing logic. TTL stands for transistor - transistor - logic. It involves transistors (BJT) to implement logic. TTL applies means TTL logic family is used or can be applied in that specific application.
TTL is a logic family. A logic family is the set of logic gates designed using a specific approach. Or simply speaking, logic family is the way of implementing logic. TTL stands for transistor - transistor - logic. It involves transistors (BJT) to implement logic. TTL applies means TTL logic family is used or can be applied in that specific application.
TTL stands for "transistor-transistor logic" and consists of using BJT's ("bipolar junction transistors") to conduct the logic for the circuit.
transistor transistor logic
TTL
The switching time (on and off) of the TTL logic gate is very fast in comparison with CMOS logic gate. However, they could not tolerate higher range of power supply.
Briefly, TTL uses more power than more modern families.
In electronics TTL stands for Transistor Transistor Logic.
it is in micro seconds
TTL stand for transistor transistor logic it could be DTL for diode or any other type of family.
because TTL have a bias input setup to eliminate noise therefore the output will follow the logic one input if left open