answersLogoWhite

0

It could possibly be an additive in the fuel. Some types of fuel injector cleaner can clean as well as possibly damage fuel injectors. It's also possible that debris from somewhere in the fuel lines is getting into them. It wouldn't hurt to change the fuel filter and check the fuel pressure to see if the fuel pump is operating correctly. Another possibility might be the electrical side of the system.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What would cause a Daewoo lanos to shut down when it get hot?

Could be a coil or ICM, Ignition Control Module.


What would cause a 2002 Daewoo Lanos bog down when gas is applied?

Fuel Pump! That's what happened to mine.


What would cause rear wheel to lock in a Daewoo Lanos?

the brake has seized take the wheel off and beat the brake with a hammer


What would cause the back window demister not to work on Daewoo Lanos 1400cc?

if the demister does not work,you should check the contacts on the respective windshield or it also could be a problem with the relay


If the timing belt on a 2000 Daewoo Lanos 1.6 breaks will it damage the valves?

Yes If you know that it is broke don't attempt to start it or you cause more harm if harm isn't already caused


What would cause a Daewoo lanos to burr loudly when you push your clutch in.. what could it be?

Sounds like the thrust bearing is worn, gearbox out to change this, may as well change clutch at same time.


What would cause a 1999 Daewoo Lanos SE 1.4 liter to run poorly where the engine seems to roar but lacks power?

Yes, as the mixture would run lean and possible misfires could occur.


Your Daewoo lanos is making a knocking sound what do you do?

I would recommend taking it to a mechanic and have them listen to it. Everyone's definition of "knocking" is slightly different. Try not to drive it for too long; engine knocks can usually cause pretty severe damage to an engine.


Where is the fuse for the fog lights in a Daewoo lanos?

In a Daewoo Lanos, the fuse for the fog lights is typically located in the fuse box, which is usually found under the dashboard on the driver's side or in the engine compartment. You can identify the specific fuse for the fog lights by consulting the fuse box diagram, usually found on the cover of the fuse box or in the owner's manual. Make sure to check the fuse rating to ensure it's the correct one for the fog light circuit. If the fog lights are not functioning, a blown fuse may be the cause.


How to check for bent valves on 2001 Daewoo Lanos?

compression check The Daewoo Lanos has an interference engine, if the timing belt failed, there is a strong possibility the pistons hit valves before the engine stopped completely. First perform a compression test, if the valves are bent they will not seal properly and the compression readings will be low. Keep in mind if the timing belt is broken or not installed correctly, this could cause cylinders to have low compression also. Inspect with a fiber optic borescope through the spark plug holes, look for impressions in the piston tops. The fiber optic borescope can help by giving an indication of the damage that may have occured without disassembly.


What would cause a 2000 Daewoo Lanos 1.6 to idle okay but no power and the engine roars as it chugs along when driving?

If you have a manual transmission, then it sounds like your clutch is slipping and needs to be replaced. If the RPM's of the engine are roaring and your car is barely moving, that would be my first assumption. Mechanic.


What causes the check engine light to stay on in a 1997 Daewoo Lanos?

The check engine light on a 1997 Daewoo Lanos can stay on due to various issues, including a malfunctioning oxygen sensor, a faulty mass airflow sensor, or problems with the vehicle's emissions system. It may also indicate issues like a loose or damaged gas cap, engine misfires, or problems with the ignition system. To diagnose the exact cause, it's advisable to use an OBD-II scanner to read the trouble codes stored in the vehicle's computer. Regular maintenance and timely repairs can help prevent the light from staying on.