0
What fuse controls the brake lights on a 2002 dodge dakotaall lights and turn signals work except no brake lights when brake pedal is pushed?
Something you may not realise is that the brake light bulb is often one bulb with two elements. One of the elements will be for the brake and the other will be for the tail lighting for example so,when tested, the actual bulb will still light up because the second element is unaffected. Make sure that the 'blown' bulb that you are actually changing is not in fact your fog lamp. This will not automatically light up when you test your lights as you have to operate this light separately (similarly to indicator lights). So the fog lamp bulb will appear to be the only one not lit up when you test your lights. Find the bulb with two elements inside and change that one. Sounds obvious (and may be obvious to many) but it's a common mistake. Hope this helps!.
What else can I help you with?
Where is controls for top and also dash board lights flash all the time put new dimmer switch no help please help?
replace burn out dash lights bulbs.make sure to put them in the same hole they came from.I did not and my turn signals did not work till i got the bulbs in the right place.dont know if this will help but you said dash board lights and this is my story.
How to fix Dash lights Saturn SC2 98?
First you have locate the knob or the dial controls. This is what brightens the lights on your dashboard. Then you need to check the fuse that controls the dashboard lights. Most of the time the fuse needs a simple replacement.
How were microprocessors for automobiles developed?
* ECU- controls engine functions * Airbag Module- controls airbag deployment * Body Controller- controls interior lights, door locks, windows, seats, etc * Driver's Door Module- communicates commands from switches on drivers door to the body controller * Cruise Control Module- Regulates speed while in cruise control * Climate Control Module- Monitors interior temperature and controls the heating and cooling systems * Transmission Controller- controls automatic transmission * ABS Module- controls anti-lock brakes and may handle the traction-control and stability-control systems * Power Distribution Box Module- controls relays in the power distribution box * Instrument Panel- Controls gauges, and indicator lights using data from the communications bus
Where the brake light relay is on a 2000 mercury cougar or why the brake lights wont work the fuses and lights are good?
Check the brake light switch first. It is usually near the brake pedal under the dash. A bad turn signal switch can also cause this if the brake lights are also turn signal lights. If the brake lights are independent of the turn signals then disregard the switch problem. A good wiring diagram will help to diagnose the problem also. Check with dealership mechanics as they have access to diagrams.
What was church like in the 1800s?
It was very similar to today except for no electric music or lights. Sermons haven't changed that much - they're still about trying to do good and avoid evil.
What fuse controls the brake lights on a 92 Dodge Dakota. All lights and turn signals work except no brake lights when brake pedal is pushed?
Fuse 7 controls the brake lights. It should be a red 10amp fuse.
What fuse controls the brake lights on 2001 Dodge Van all lights and trn signals work except no brake lights when brake pedal is pushed?
It is not necessarily the fuse. It could be the switch on the brake that is not closing the circuit.
What fuse controls the brake lights on 1976 Chevrolet Van All lights and turn signals work except no brake lights when brake pedal is pushed?
After fuse (should be labeled) Try bulbs and defective stop light switch
What fuse controls the brake lights on a 96 crown Victoria All lights and turn signals work except no brake lights when brake pedal is pushed?
If all the fuses are good, then most likely the brake light switch right on the brake pedal inside the car. Check that.
What fuse controls the brake lights on a 90 Dodge Dakota. All lights and turn signals work except no brake lights when brake pedal is pushed?
After further research I am answering my own question. It is fuse number 6 on the fuse block located under the dash and is a 10 amp fuse.
Which fuse controls the tail lights on a 1991 ford explorer?
generally the tail light fuse is the same fuse as the turn signals
What fuse controls the brake lights on a 96 Chevy 1500 All lights and turn signals work except no brake lights when brake pedal is pushed?
I'm not exactly sure which fuse it is, but it doesn't sound like a fuse to me. I would check the switch on the pedal, just simply short acrost it from terminal to terminal with a screwdriver, if the brake lights come on, the switch on the pedal is bad, if they don't then it probably is a fuse.
What fuse controls the brake lighta on a 2000 dodge caravan. all lights work except no brake lights when pedal is pushed?
Check the brake light switch on the brake pedal
You have an 88 bronco 2 head lights were working fine the night before next night no headlights except on bright and no turn signal either but the hazard lights work Any suggestions fuses looked fine?
Your switch in the steering column that controls the high beems and the turn signals is bad. I have had to change it on both 1987 bronco ii that I have owned. Not to difficult to do.
What fuse controls the dash lights turn signals and tail lights of a 2000 Saturn L-series sedan?
Underhood Minifuses control the items in question. Fuses should be labeled, but if not you're on your own. BRAKE (Blue 15a) control brake lampls; HAZARD (Red 10a) controls Hazard Flasher, Inst Pnl, Turn Signals, Park/Turn lts and Rear Tail lts
Where is the hazard flasher in a 1990 Subaru Legacy?
Under the center of the dash, in front of the console, mounted on the firewall. This one flasher controls the hazard lights and turn signals.
What are the different types of signals and lights used on bikes for communication and safety purposes?
Bikes use signals and lights for communication and safety. Common types include hand signals for turning, brake lights for stopping, and front and rear lights for visibility.
