when he connected the parts he got an electric current.
complex circuit
parallel
Simple parts of a circuit are switches, light bulb, battery and connecting wires.
When all parts of a circuit are composed of conducting materials, the circuit is said to be closed. One condition could be a closed circuit, however it could be open if the components are not assembled or are assembled incorrectly.
If there are only a resistor and a capacitor in the circuit, then the phase shift will indeed be between 0 and 90 degrees. When the resistor and capacitor are in series, the phase shift will be negative when the capacitor is connected to a source voltage and the resistor is the load. The phase shift will be positive when the resistor is connected to the source. The lower the values of R and C, the higher the frequency bandwidth.With the resistor and capacitor connected in series and the two parts connected to a current source, the phase shift will be negative. At high frequencies, the output voltages is lower, and the circuit appears as a very low impedance. At low frequencies, the circuit looks more like a resistor. Again, the phase shift will be between 0 and 90 degrees.CommentThe correct term is phase angle, not 'phase shift'. By definition, the phase angle is the angle by which the load current leads or lags the supply voltage. For an RC circuit, the current leads the voltage, so the phase angle is a leading phase angle.
An electric current flowed around the circuit.
A circuit in which all parts are connected in a single loop
oppen circuit
In an open circuit, the electrons cannot flow easily because one of the parts in a circuit is not connected, whereas, in a closed circuit all the parts are connected, therefore, the electrons can flow easily. Hope this helps:)
A series circuit is one is which all current is restricted to one path. A good example of a device that is series-connected is a circuit breaker.
A series circuit seems to fit this description.
A line. This represents either wire, solder or foil run on a circuit board. These can end and have a page or other notation meaning it is continued elsewhere on the page or on another page.
That is a series circuit, all parts have the same current flowing through, and the voltages add up.
Series.
In series. In other words - from end to end in a loop.
That is a series circuit. An example is old christmas tree bulbs where if one burned out they all went dark.
The parts in an electric circuit are as follows: wires that contain two D-cells, a light bulb, and a switch, the D-cells are the energy source, the bulb is the load, the switch controls the flow of electric charges and the connecting wires provide a complete path that joins all the parts together.