0
What if only one brake light works AND THERE IS NO POWER TO THE BULB?
Wiki User
∙ 17y ago
In that case, start tracking back. The turn signal switch pulls the brake light out of circuit when the signal is operating. If the switch fails, the one or both stoplights can stop working.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
No jeep liberty passenger side brake light - changed bulb - checked plug with tester and power is present - but still no brake light - tried second new bulb and still no luck.?
double filament bulb installed incorrectly defective socket bad ground
Why does the brake light on the integra not light up when you turn on the light but it light up when you brake?
The Integra uses a dual-filament bulb in the tail light, which has one contact for the running light (the lights you turn on at night) and another brighter one for the brake light (only goes on when you press the brake pedal). You have replaced the bulb with the wrong type. You will need a 2057 bulb for the Integra.
The power delivered to the light bulb is 23.1 W. What are the two possible resistances of the light bulb?
A: HARD TO SAY because a bulb has different resistance as it warms up
What is the Electrical power for a lightbulb?
The power rating for a light bulb (like "40 W") tells how much electrical power the light bulb uses. All of the power used by the bulb is either converted into light or heat. In an incandescent bulb, most of the energy becomes heat. In a fluorescent bulb, more of it becomes light.
Your brake lights have stopped working Fuses ok?
Is the light bulb inside burnt out. If so, that would do it.
2000 Nissan Frontier my tail lights work but my left brake light doesn't how do I fix this?
check the bulb, it has two filaments, one for tail light, another for brake light and indicator. if the turn signal works, it's not the bulb, but a power supply problem.
97 ford ranger tail light works but brake light doesnt-- has new bulb and fuse?
check brake light switch
2003 Dodge Ram 1500 and the left brake light will not work you have changed the bulb and checked the fuses all are good The right brake light works fine What else could be the problem?
compare the bulb make sure it is the right number bulb or check inside the sucket and see if the connection are not damage or get a test light to see if there is power comming to the back when the brake is depress
How do you repair a tail light of a Mitsubishi eclipse 1996 that is not working when you turn on the headlight but works when you brake?
Replace the bulb it works when you turn on the driving lights and when you brake. there are two little springs inside the light one is for the brake light and the other is for the driving light. All you need to do is replace the bulb. good luck.
Right side brake light goes out but left side works?
Check the bulb.
Your tail light works on both sides but your brake light which is the same bulb is not working on the passenger side you changed the bulb but the brake light still does not work What could your proble?
your car wiring is screwed up get someone to check on the brake wiring.
Your tail light is out but the brake light works on your Toyota Previa what should you do?
Replace the light bulb. Tail lights are usually dual filament, 2 filaments in one bulb.
What does the brake bulb light mean on a 2004 Honda Pilot?
The "BRAKE BULB" light means that a brake bulb is not working and may require replacing.
1999 Ford Explore All the light bulbs are working but my left brake light isn't Would it be the brake light switch if the right brake light is still working?
No. I am assuming that you first replaced the bulb? If you did replace the bulb, then I would check to see if you are getting power to the bulb socket. If no power is getting to the socket, you then need to find the break in the electric lines going to the socket.
I have a ford contour and the tail light and brake light is the same bulb but the brake light WORKS but not the tail light what can be the problem. I CHANGE THE BULB TWICE?
When the tail light and break light are on the same bulb said bulb has 2 elements, one for the break and the other for the tail light, one element is burned out. Replace the bulb. If you've replaced the bulb, it might be the wiring. The holder for the bulb sometimes is at fault. They are $40.00 at the dealer, but at a pick a part or salvage yard they are $2.00.
What style bulb for 1999 ford explorer brake light?
bulb # for brake light on your explorer is a 3157 backup light bulb # is 3156 hope this helps
Why is the brake light in 2004 Toyota Highlander not working?
a. is the power on? b. have you put your foot on the brake ? c. has the bulb/fuse gone?
