0
M ohm means "mega ohm". That is 106 = 1,000,000 ohms.
Dulce Hickle
Add your answer:
Earn +20 pts
Which scientist created the ohm?
The ohm is a measurement of resistance named after Goerg Ohm. It was not "created".
How many 3 ohm's resistors must be connected in a parallel to have a total resistance of 0.6 ohm's?
5CommentThe plural of ohm is ohms, not ohm's!
What is the duration of Ohm Krüger?
The duration of Ohm Krüger is 2.25 hours.
How many ohm in one mega ohm?
1 megohm is 1 million Ohms
60 ohm and 40 ohm and 20 ohm resistors are all 3 connected in series across a 120VAC source what is the total voltage across 40 ohms resistance?
Total resistance is 120 ohms. The 120VAC will be split evenly over this 120 ohm load, so every ohm of resistance gets a volt. So there will be a 40 volt drop across the 40 ohm resistor.
How many ohm m for 1000 ohm cm?
10 ohm-m
What this means m and ohm is it mohm?
mega ohm
Is M and the ohm symbol together OK for Mega ohm?
Yes, the symbol for megaohm (or megohm) is MΩ.
What is the SI unit of resistance?
The SI unit of resistance is Ohm. Ohm was named after German physicist George Simon Ohm. The base units for resistance are Ohm equals kg m squared.
Insulation resistance test limits on current transformers?
in primary side 400KV SYSTEM = >400 M OHM 200KV SYSTEM = >200 M OHN in secondary side <1 M OHM
Specific resistance of a pure germanium?
60 ohm-m?
What is the electrical resistivity of stainless steel?
7.184E-07 ohm-m
What is the resistivity of copper at 77 K?
0.213 n ohm - m
The electrical conductivity of metals which is expressed in ohm-1 m-1 is of the order of?
In the range of 1 x 10^7 1/ohm-m . That's one times ten to the seventh power.
Is 0.746 M ohms greater than 1 K ohm?
Yes.
What does OHMS stand for?
The ohm is a measure of electrical resistance. It was named for the German physicist Georg Ohm.
How to check register using multimeter?
first of all set multimeter to register section set the ohm rang as per the requirement (ohm, K ohm, or M ohm) set the both the end of multimeter wire at the both end of the register and note down the result which is displayed on the screen
