The dielectric is composed of "molecules" that are actually perfectly conducting spheres. These have radius R and are in a cubic array with spacing much greater than the radius R. With the application of a voltage, the spheres acquire the positive and negative surface charges on their northern and southern poles required to make their surfaces equipotentials. In so far as the field outside the spheres is concerned, the system is modeled as an array of dipoles, each induced by the applied field.
E = Eo/k k is dielectric constant
capacitors are classified on the basis of dielectric material used inside it. For example the electrolytic capacitor consist electrolyte as dielectric mica capacitor consist mica as dielectric between plates and ceramic capacitor consist ceramic as dielectric.
dielectric grease.
Capacitors are, in principal, two parallel plates separated by something (the dielectric). This dielectric can be many things, in fact most non-conductive things, air is just one. Warning, heavy science (way way above my level) http://en.wikipedia.org/wiki/Dielectric#Some_practical_dielectrics Photo of variable air dielectric capacitor, used to be used to tune radios for example. You can see the plates and air gap. http://en.wikipedia.org/wiki/File:Variable_Capacitor.jpg G
The capacitor will hold the charge, until it leaks off due to resistances in the dielectric or external.
For an insulating material dielectric strength and dielectric loss should be respectively
dielectric constant
For an insulating material dielectric strength and dielectric loss should be respectively high or low
why need dielectric test for transformer
The dielectric,usually the insulator between the plates of a capacitor, can be overstressed by the application of too high voltages applied to the capacitor plates. The dielectric breaks down and a current flows between the plates until,either they are discharged, or an equilibrium is reached,below the working voltage of the capacitor. If the dielectric is damaged in this process he capacitor must be replaced. Some dielectric material self heal and can recover from an over voltage.
Capacitors are named after their dielectrics. So, an 'air capacitor' uses air as its dielectric, a 'mica capacitor' uses mica as its dielectric, and so on. There are lots of different dielectric used to separate the plates of a capacitor, each with different permittivities and dielectric strengths. As the perfect dielectric (i.e. one with both a very high permittivity and a very high dielectric strength) doesn't occur, the choice of dielectric is always a compromise between it permittivity and dielectric strength.
dielectric constant for sodium Hypochlorite
Thermal loss in dielectric heating
A leaky dielectric is a poorly conducting liquid. Refer to "ELECTROHYDRODYNAMICS: The Taylor-Melcher Leaky Dielectric Model" for more information.
high and high
No, these are two unrelated properties of a material.
The dielectric breakdown strength is 3,000 volts per millimeter.