The amount of curvature given to the leaf and observed from the main leaf upto the point just below the centre of the either of the end eyes of the spring.
it doesnt
A camber plate is a vehicle part that is used in adjusting the alignment of the front end of the vehicle. These basically work together with the spindles and struts.
You might try an auto parts store -- leaf spring shims.
According to the Service Manual I have, it's 11.5". This is measured from the top of the rubber spring to the bottom of the aluminum piston of the left hand side of the truck. All others should match.
idk .!:/ I'm asking tha same question 4 a stupid leaf project 4 school .
A leaf spring may be classed as "bad" under the following conditions: Ride height is noticeably reduced; spring leafs are cracked or broken; spring eye bushings, pins or shackles are worn. Most leaf springs can be rebuilt at your local spring shop.
Attaching a leaf spring to a chassis
A set of leaf spring that is so mounted that it is at right angles to the length of the Vehicle is known as the transverse leaf spring.
the spring height is 1.25 in. shorter but the spring rate is different and the leaf springs are also different.
the eye of a leaf spring, assuming u mean the eye at end of spring, is used to bolt the spring to the vehicle
When camber specifications are determined during the design stage, a number of factors are taken into account. The engineers account for the fact that wheel alignment specifications used by alignment technicians are for a vehicle that is not moving. On many vehicles, camber changes with different road speeds. This is because aerodynamic forces cause a change in riding height from the height of a vehicle at rest. Because of this, riding height should be checked and problems corrected before setting camber. Camber specs are set so that when a vehicle is at highway speed, the camber is at the optimal setting for minimum tire wear. For many years the trend has been to set the camber from zero to slightly positive to offset vehicle loading, however the current trend is to slightly negative settings to increase vehicle stability and improve handling.
optimized dimensions of a mono leaf composite spring
mono leaf
the leaf spring on a vehicle's axle is an example
leaf spring front pivot bolt 115 ft/lbs leaf spring rear upper shackle bolt 115 ft/lbs leaf spring lower shackle bolt 80 ft/lbs
No. A coil spring has coils, no leafs. A leaf spring has leafs, anywhere from one leaf to many leafs depending on the application.
At the leaf spring store!