On a vehicle it is a Mass AirFlow sensor. It measures the amount of air going into the engine.
It means you have low voltage to the sensor. Before you replace it, get a simple multimeter, check the voltage on the clip for wire, you can google which wires to test and how, then upstream on the same wire, i had the same issue. It turns out the maf was fine, the wire clip that attaches to the sensor was bad. It caused the car to rev in idle and the transmission would hit hard when going from park to drive. All this was cured with a $ 40 replacement wiring clip. Check wiring first, i had all kinds of advice from low cost such as throttle position sensor, IAC valve and MAF replacement.
don't really know, went on the MAF website and it doesn't really answer any of my questions that i need to know about what they do :/
You are allowed to take home no more than 10 Paua's a day and they must be over 125mm (though some regions might allow 120mm, consult your local MAF office).
No. MAF biosecurity will confiscate the item at the airport and offer you 3 options. 1. Have it destroyed (no charge) 2. Have it treated at a cost to you and will take a few days and then be sent to you. 3. Have it shipped back to the country of origin. this will cost also.
If you lift the hood, remove the air box (disconnecting the inlet air temp and MAF) and look straight down onto the motor you will see the water temp sensor that is the one that controls the cold engine start. The coolant sensor the controls the gauge is inside and you have to remove the engine cowl
It does not have a MAF.
A 1997 Chrysler does not have a MAF sensor.A 1997 Chrysler does not have a MAF sensor.
'93 models had speed-density, not MAF. MAF was started in '94
It does not have a MAF.
It does not have a maf.
It does not have a maf sensor.
No MAF, it uses a MAP.No MAF, it uses a MAP.
It does not have a MAF, it uses a MAP which is on the throttle body.It does not have a MAF, it uses a MAP which is on the throttle body.
Yes. Most parts stores carry MAF Cleaner in a spray can. If your MAF is grimey, it can cause your engine to run rough, hesitate, etc... MAF Cleaner will help a lot. Just be careful handling the MAF, it's a delicate part.
It does not have a maf sensor.
I4 does not have MAF.
That truck does not have a maf sensor.