its the alternatingg current
AnswerA load is any device, or group of devices, that draws energy from an electrical supply.
For example
In another use of the term, we say that a generator or transformer is 'loaded' when it connected to a load, but is 'off-load' when it is operating but not connected to a load.
In a parallel circuit an electrical load may be disconnected without affecting other loads.
The function of a light bulb in an electric circuit is that it turns electrical energy into light.
Consider two points (A and B) in an electric circuit. An open circuit between A and B means there is no electrical connection between A and B. A short circuit between A and B means there is an electrical connection between A and B.
A basic electrical circuit needs a voltage supply (battery or household outlet), wiring to carry electrons to and from the voltage supply to the load, and a load (motor, light, heat element, stereo, blender, whatever).
No. No load and short circuit is not similar. No load can be 1) Either open circuit i.e. Only Potential is available and load is not connected 2) Load (i.e. motor etc ) is connected but not working with full load or full capacity. In this case the current will flow through the circuit depending on the load. It means No load condition is a condition where no current or a small ( relative / comparative term) current is flowing through the circuit. In Short circuit the load side resistance/ impedance become so less that very high amount of current is passing through circuit.( The protection is therefor required for any circuit) No load and and short circuit is not similar. Thanks
In a circuit, the electrical line provides power to the load, which is the device using the electricity. The line carries the electrical current to the load, allowing it to operate. The load consumes the electrical energy provided by the line to perform its intended function.
In a circuit, the electrical line carries the current from the power source to the load, which is the component that uses the electricity to perform a specific function. The line supplies power to the load, while the load consumes the power to operate.
A load increases the flow of electrical current in a series circuit. No load, no flow.
it's function is to supply energy(electric)
No, a switch is not considered a load in an electrical circuit. A switch controls the flow of electricity to the load (such as a light bulb or motor) by opening or closing the circuit. The load is the component in the circuit that consumes the electrical energy.
A motor is not needed in a circuit, a motor is an electrical load for the current to drive, but the circuit can perform with other types of load - such as a lamp, a transformer, a heating coil, or any electronic load. if you mean 'why does an electric motor need a circuit?' this is because the motor is an electrical device which has coils of wire to produce a magnetic field, without the circuit it cannot function.
The term used to designate the point in an electrical circuit where electrical work is done is "load." The load is the component of the circuit that consumes electrical energy and converts it into another form of energy, such as light or heat.
The load that is connected to the circuit is what draws the power of the electrical circuit.
the electrical circuit, load, conductor, open circuit, switch,
The purpose of the load line neutral in an electrical circuit is to provide a return path for the current flowing from the load back to the power source, ensuring proper functioning of the circuit and safety of the electrical system.
By definition an electrical circuit is a route or path that starts and finishes at the same place. So there is no part of an electrical circuit that is not necessary, because if there were it would not be an electrical circuit.An electrical circuit needs a power source. Conductors to transmit the voltage from the power source to the load. The final component of the electrical circuit is the load that you want to energize.If you remove any of the components there will be an open circuit and the load will be impossible to operate.
In a parallel circuit an electrical load may be disconnected without affecting other loads.